FIRE PUMP SYSTEM INSPECTION CHECK LIST
AS PER NFPA-20
Project Name: ________________________________________________
Address: __________________________________________________________
Representative Name: _______________________________________________
Designation: _______________________________________________________
Phone: _______________________________ Fax: ________________________
E-mail: ________________________________________________
Inspection, Testing & Scope Action Taken
Maintenance: Weekly
Tank level (One third) Visual Inspection
Checking
Tank float switch Visual Inspection
Testing
Solenoid valve operation Visual Inspection
Testing
Diesel Water in system Checking
Cleaning
Engine
System Flexible hoses and connectors Visual Inspection
Oil level Visual Inspection
Checking
Lube oil heater Checking
Level (Cooling system) Visual Inspection
Checking
Adequate cooling water to heat Checking
exchanger
Water pump(s) Visual Inspection
Condition of flexible hoses and Visual Inspection
connections Checking
Jacket water heater Checking
Leakage (Exhaust system) Visual Inspection
Checking
Drain condensate trap Checking
Case exterior clean and dry (Battery Testing
system)
Specific Gravity or state of charge Visual Inspection
Diesel (Battery system)
Engine
System Charger and charge rate (Battery Checking
system)
Equalize charge (Battery system) Checking
Circuit breakers or fuses (Electrical Visual Inspection
system)
Inspection, Testing & Scope Action Taken
Maintenance: Quarterly
Strainer, filter, or dirt leg, or Cleaning
combination there of
Crankcase breather (Lubrication Visual Inspection
system) Changing
Cleaning
Diesel Water strainer (Cooling system) Cleaning
Engine
System Insulation and fire hazards (Exhaust) Visual Inspection
system)
Terminals clean and tight (Battery Visual Inspection
system) Checking
Wire chafing where subject to Visual Inspection
movement (Electrical system) Checking
Inspection, Testing & Scope Action Taken
Maintenance: Annually
Lubricate pump bearings Changing
Pump Check pump shaft end play Checking
System
Check accuracy of pressure Checking
gauges and sensors Changing
Check pump coupling alignment Checking
Mechanical Lubricate coupling Changing
Transmission
Lubricate right-angle gear drive Changing
Trip circuit breaker (if mechanism Testing
provided)
Inspect and operate emergency Visual Inspection
manual starting means (without Testing
power)
Electrical Tighten electrical connections as Checking
System necessary
Lubricate mechanical moving parts Checking
(excluding starters and relays)
Calibrate pressure switch settings Checking
Tank vents and overflow piping Checking
unobstructed Testing
Piping Visual Inspection
Rod out heat exchanger Cleaning
Inspect duct work, clean louvers Visual Inspection
(combustion air) (Cooling system) Checking
Diesel Changing
Engine
System Excessive back pressure (Exhaust Testing
system)
Exhaust system hangers and Visual Inspection
supports (Exhaust system)
Clean terminals (Battery system) Cleaning
Tighten control and power wiring Checking
connections (Battery system)
Diesel
Engine
System Lube Oil change (Mobile) Changing
Oil Filter(s) Changing
Inspector Signature Project Manager Signature
