Scribd
Upload
46 views2 pages

Spindle Construction

The document provides specifications and construction details for the F3-660 spindle, including part codes and manufacturers for various components. It describes the spindle's operation, including its maximum speed of 20,000 rpm, lubrication system, and the need for complete cartridge replacement if the spindle bearing fails. Additionally, it highlights the use of a rotary joint for coolant circulation and the types of bearings employed in the spindle design.

Uploaded by

Edgar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
46 views2 pages

Spindle Construction

The document provides specifications and construction details for the F3-660 spindle, including part codes and manufacturers for various components. It describes the spindle's operation, including its maximum speed of 20,000 rpm, lubrication system, and the need for complete cartridge replacement if the spindle bearing fails. Additionally, it highlights the use of a rotary joint for coolant circulation and the types of bearings employed in the spindle design.

Uploaded by

Edgar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

F3-660 Spindle Page 1 of 2

Spindle Construction
Standard specifications

HSK specifications

Click on each of the drawings to see enlargement.

Name Part code Type Maker


Collet chuck (STD) M20RB009880 - RIKEN SEIKI
Collet chuck (HSK M20FG012651 - FUKUDA KOEKI
Cone disk spring (STD) 34320209150 4 x 30 set MIYAMOTO SHOKAI
Cone disk spring (HSK) A49VA001350 iMC-spring alpha TOKAI BANE
Rotary joint H50RK008490 ESX20-7066 RIX
Proximity sensor R25YB002600 FL M-2J6D YAMATAKE

 The spindle is driven by an AC inverter motor and its maximum speed is 20000
rpm. A cutting tool is clamped in the spindle by spring force and a hydraulic
cylinder is used to force out the cutting tool from the spindle. Cooling fluid is
circulated around the spindle outer casing to minimize temperature rise of the
spindle due to generation of heat from the bearings.

 The spindle is driven by the built-in motor, consisting of the motor (rotor) and the
cartridge which cannot be separated. The speed and the orient position are
detected by the PLG sensor.

 Angular contact bearings are used in the front part of the spindle and roller
bearings are used in the rear part. Both are lubricated by oil-lubrication system

https://ser.mazak.co.jp/MAZAK/sghp/mnt/ef3-660/spindle/head01.htm 17/12/2008
F3-660 Spindle Page 2 of 2

and checked by the pressure switch.

 The RIX rotary joint is used for the through-coolant specifications.

Spindle cartridge

If the spindle bearing is broken, the entire spindle cartridge needs to be replaced with a
new one because only the bearing cannot be replaced in the field.

Part code Specifications


52600100102 BIG-PLUS FANUC
52600100900 HSK-A63 FANUC
52600150300 HSK-A63, for Aishin AW
52600150902 AHO tool, for Aishin Koki

Length: about 1000 mm


Weight: about 120 kg

https://ser.mazak.co.jp/MAZAK/sghp/mnt/ef3-660/spindle/head01.htm 17/12/2008

You might also like