LED Explanation

©2022 TP-Link 7106509691 REV 5.0.1

PWR
On: Power on
Off: Power off

Enlarge Your Ethernet Network Link/Act

Gigabit Single-Mode Media Converter
On: Valid link
Flashing: Transmitting or receiving data
Off: Invalid link

Package Contents: Converter, Power Adapter, Installation Guide

Scenario 1: Connect Devices with and without Optical Interfaces

Media Converter
Ethernet Device Ethernet Device
with Optical Interfaces without Optical Interfaces
PWR
TX RX

1000BASE-LX Gigabit Ethernet

1000BASE-LX Gigabit Ethernet

LC-SC/UPC Fiber Cable Twisted-Pair Cable

 Scenario 2: Connect Devices without Optical Interfaces
Ethernet Device Media Converter Media Converter Ethernet Device
without Optical Interfaces without optical Interfaces
Gigabit Ethernet 1000BASE-LX
PWR
TX RX

Gigabit Ethernet Gigabit Ethernet

RX TX
PWR
1000BASE-LX Gigabit Ethernet

Twisted-Pair Cable Fiber Cable Twisted-Pair Cable

Note: Connect the TX port of one converter to the RX port of the other using a fiber cable.

Specifications
General Specifications Environmental and Physical Specifications
IEEE 802.3, IEEE 802.3i, IEEE 802.3u, Operating Temperature 0˚C to 50˚C (32˚F to 122˚F)
Standards
IEEE 802.3ab, IEEE 802.3x, IEEE 802.3z Storage Temperature -40˚C to 70˚C (-40˚F to 158˚F)
LED PWR, Link/Act
Operating Humidity 10% to 90% RH non-condensing
Connector 2 SC fiber optic; 1 RJ45 jack
Storage Humidity 5% to 90% RH non-condensing
100BASE-TX: 2-pair UTP/STP of Cat. 5 or above (≤100 m)
Twisted-Pair
1000BASE-T: 4-pair UTP/STP of Cat. 5e or above (≤100 m)

Fiber 9/125 μm single-mode fiber

Transmission To ask questions, find answers, and communicate with TP-Link users or
≤20 km
Distance engineers, please visit https://community.tp-link.com to join TP-Link
Community.
Wave Length 1310 nm For technical support and other information, please visit
Power External Power Adapter: 9 V/0.6 A https://www.tp-link.com/support, or simply scan the QR code.
If you have any suggestions or needs on the product guides, welcome
Dimensions 94.5x73x27 mm to email [email protected].

Safety Information
• Keep the device away from water, fire, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
• Do not use damaged charger or USB cable to charge the device.
• Do not use any other chargers than those recommended.
EU declaration of conformity
• Adapter shall be installed near the equipment and shall be easily accessible. TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU,
• Do not point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can injure your eyesight 2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863.
• Use only power supplies which are provided by manufacturer and in the original packing of this product. If you have any questions, please don't The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce.
hesitate to contact us.
• The operating temperature mentioned above is only applicable to the media converter. For the power adapter, the operating temperature shall UK declaration of conformity
be within 0˚C to 40˚C (32˚F to 104˚F).
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of the Electromagnetic
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due Compatibility Regulations 2016 and Electrical Equipment (Safety) Regulations 2016.
to improper use of the device. Please use this product with care and operate at your own risk.
The original UK declaration of conformity may be found at https://www.tp-link.com/support/ukca/