DeltaV Distributed Control Systems Product Data Sheet

August 2022

S-series Horizontal Carriers

The DeltaV™ modular I/O subsystem is easy to install and maintain.

„ Modular design allows flexible installation Introduction

„ Allows you to expand online The DeltaV™ S-series hardware takes the proven DeltaV
hardware to a new level of robustness and ease of use.
„ Integrated power distribution
Assembly is faster and power distribution is easier, with fewer
„ Snap in assembly connections using the integrated field power distribution and
increased capacity of I/O bus power.

The modular design allows you to purchase only what you need
with the ability to expand online later simply by adding the
power/controller and I/O carriers are modular. Purchase only
what you need but be assured that as your system grows you
can add plug-and-play carriers—Easy!
S-series Horizontal Carriers August 2022

Benefits Snap In Assembly. All components snap into place without the
use of special tools. The design supports and “easy on” design
Modular design allows flexible installation. A T- type DIN rail to speed up installation and reduce maintenance turnaround.
is all you need to mount the power/controller carrier into place. Carriers snap onto T-DIN Rails. All interfaces and system power
Snap the I/O interface carriers to the rail and slide to connect supplies snap into place, eliminating retention screws.
it to the carrier on the left. Add as many carriers as needed,
or use extender cables to move to a new rail. The DeltaV Product Description
system’s modular design approach allows you to add I/O The S-series IO subsystem has been redesigned with a focus
carriers as you need them. on fast assembly and simplified power connections. The system
Allows you to expand online. Additional 8-wide carriers may uses only 24V DC bulk power supplies. All power is connected
be added online as desired. Bus extenders provide dual cabling to system carriers. Bus connectors have been upgraded to
for robustness, allowing up to 8 I/O carriers for a total of 64 support additional 12V DC power to the IO cards, allowing
simplex cards or 32 redundant cards. additional power carriers to be inserted anywhere along
the bus.
Integrated power distribution. Controller and I/O interface
power distribution is integrated into the carriers to reduce and Carriers mount to standard t-type DIN rail with latches that
simplify power and grounding. I/O Carriers have an integrated require no tools for quick installation. The latches can be
shield ground bar to isolate and drain field noise away from released using a blade screw driver. Simply snap the carrier
system power. They also provide an integrated redundant 24V to the rail and slide adjacent carriers together to engage the
DC bussed field power distribution to reduce installation wiring bus connector.
and provide fused, isolated power to each I/O interface, using The I/O carrier supports 8 IO modules. Each card can be
Power Buss Plugs. Alternatively, the I/O carriers can be ordered connected to an internal 24V DC bus using the Power Buss
with Power Terminal Plugs to bring dedicated power to each Plugs, or it can be individually powered by using the
card, which can be either 24V DC or 120/230V AC. Power Buss Power Terminal Plugs. The internal 24V DC bus is divided into
Plugs and Power Terminal Plugs can be mixed on one primary and secondary power, with primary power distributed
I/O Carrier. to odd numbered slots and redundant power distributed to
A single Power Terminal Plug will come with any 120V AC DI even numbered slots using the Power Buss Plugs.
or 120/230V AC DO card.

The DeltaV modular I/O subsystem is easy to install and maintain

www.emerson.com/deltav 2
S-series Horizontal Carriers August 2022

Hardware Specifications
Specifications for S-series Power/Controller carriers
24V DC Power Input 8 amps

Power/Controller Carrier 2 Power supplies or 1 power supply with 1 Controller

Specifications for S-series Horizontal I/O carriers

Backplane Current 15 Amps

Power Terminal Plug 12 Amps

Power Buss Plug (fused) 5 Amps

Primary/Secondary 24V DC Bussed 12 Amps per bus (Max 3 A per card)
Power Distribution
IO Carrier Capacity 8 IO modules
Environmental specifications

Operating Temperature* -40 to 70°C (-40 to 158 °F)

Storage Temperature -40 to 85°C (-40 to 185 °F)

Relative Humidity 5 to 95%, non-condensing

Airborne Contaminants ISA-S71.04-1985 Airborne Contaminants Class G3 Conformal coating

Protection Rating IP 20

Shock 10 g ½-sine wave for 11 ms

Vibration 1 mm peak-to-peak from 5 to 13.2 Hz; 0.7 g from 13.2 to 150 Hz

*Operating any electronics at the higher end of its temperature range for long periods of time will shorten its expected lifetime,
see Effects of Heat and Airflow Inside an Enclosure White Paper for more information.

www.emerson.com/deltav 3
S-series Horizontal Carriers August 2022

System Compatibility Hazardous Area/Location

S-series carriers support S-series controllers, power supplies The S-series Horizontal Carriers can be installed and used based
and I/O cards. M-series I/O cards are not supported on on the following standards (see actual certificates for exact
S-series controllers. product markings for each product):

DeltaV SIS logic solvers can be installed under an S- series „ FM (USA):

controller using SIS horizontal and vertical carriers. The DeltaV Class I, Division 2, Groups A, B, C, D, T4
SIS S-series adapter enables M-series horizontal carriers to be
connected to S-series controllers. This enables logic solvers to „ cFM (Canada):
be installed on the same nodes with S-series controllers and I/O. Class I, Division 2, Groups A, B, C, D, T4
S-series hardware is designed around 24V DC bulk power, „ ATEX:
for both controller and I/O interfaces. 12V DC bulk are not
II 3G Ex ec IIC T4 Gc
supported on the 2-wide Power/Controller carriers.
„ IEC-Ex:
Certifications II 3G Ex ec IIC T4 Gc
The following certifications are available for the Regarding the Installation instructions please refer to the following Documents:
Class 1 Division 2 Installation Instructions DeltaV S-Series (12P5402)
S-series Horizontal Carriers (see actual certificates Zone 2 Installation Instructions DeltaV S-Series (12P5404)
for exact certifications for each product):

„ CE:
EMC- EN 61326-1

„ FM:
FM 3600

FM 3611

„ CSA:
CSA-C22.2 No. 213
CSA-C22.2 No. 1010-1

„ ATEX:
EN 60079-0

EN 60079-7

„ IEC-Ex:
IEC 60079-0

IEC 60079-7

„ Marine Certifications: IACS E10

ABS Certificate of Design Assessment
DNV Marine Certificate

www.emerson.com/deltav 4
S-series Horizontal Carriers August 2022

Ordering Information
Description View Model Number
2-Wide Power/Controller Carrier SE3051C0

2-Wide Power/Controller Carrier with Dual Extender Cables 1.1m (43 in) SE3051C2

2-Wide Power/Controller Carrier with Single Extender Cable 1.1m (43 in) SE3051C3

8-Wide I/O Interface Carrier with 8 Power Buss Plugs and a Carrier Shield Bar SE4050E0C0

8-Wide I/O Interface Carrier with 8 Power Buss Plugs, a Carrier Shield Bar, SE4050E1C0
and a Single Carrier Extender Cable 1.1m (43 in)

8-Wide I/O Interface Carrier with 8 Power Buss Plugs, a Carrier Shield Bar, SE4050E2C0
and Dual Carrier Extender Cables 1.1m (43 in)

8-Wide I/O Interface Carrier with 8 Power Terminal Plugs and a CarrierShield Bar SE4059E0C0

8-Wide I/O Interface Carrier with 8 Power Terminal Plugs, a Carrier Shield Bar SE4059E1C0
and a Single Carrier Extender Cable 1.1m (43 in)

8-Wide I/O Interface Carrier with 8 Power Terminal Plugs, a Carrier Shield Bar SE4059E2C0
and Dual Carrier Extender Cables 1.1m (43 in)

DeltaV SIS S-series Adapter SE4058

Any horizontal DIN rail mounted combination of carriers and extenders requires two DIN Rail stops to prevent carriers from disconnecting. Order VE4054DRS, which is a box of 5

www.emerson.com/deltav 5
S-series Horizontal Carriers August 2022

Carrier Blank Cap Information

Description Model Number
Carrier Blank Cap (for 8-Wide I/O Interface Carrier only) SE6101

Carrier Blank Cap (for 2-Wide Power and Controller Carrier only) SE6102

Spare Extender and Cable ordering Information

Spare Parts
Description Model Number
Left Extender 1-Wide KJ4005X1-BB1

Right Extender 1-Wide KJ4005X1-BC1

Single Carrier Extender Cable 0.4m (17in) KJ4003X1-BH2

Single Carrier Extender Cable 0.8m (31in) KJ4003X1-BH3
Single Carrier Extender Cable 1.1m (43in) KJ4003X1-BH1

Single Carrier Extender Cable 1.5m (58in) KJ4003X1-BH4

Single Carrier Extender Cable 1.9m (77in) KJ4003X1-BH5

Spare Extender and Cable ordering Information

Spare Parts
Description Model Number
Power Terminal Plug for 2-Wide and 8-Wide Carriers KJ4005X1-BF1

Power Buss Plug for 8-Wide Carriers KJ4005X1-BG1

Power Terminal Plugs for 2-Wide and 8-Wide Carriers; package of 8 plugs SE6197

Power Buss Plugs for 8-Wide Carriers; package of 8 plugs SE6198

©2022, Emerson. All rights reserved.

The Emerson logo is a trademark and service mark of Emerson Electric Co. The DeltaV logo is
a mark of one of the Emerson family of companies. All other marks are the property of their
respective owners.
The contents of this publication are presented for informational purposes only, and while
diligent efforts were made to ensure their accuracy, they are not to be construed as warranties
or guarantees, express or implied, regarding the products or services described herein or their
use or applicability. All sales are governed by our terms and conditions, which are available on
Contact Us request. We reserve the right to modify or improve the designs or specifications of our products
www.emerson.com/contactus at any time without notice.