Scribd
Upload
13 views1 page

34 (TFRSC Nomenclature) Nomencard

The document outlines the TFRSC nomenclature for thread finish specifications, detailing various dimensions and points relevant to construction and inspection, such as tamper evident bead diameter and thread root diameter. It includes reference dimensions and indicates that not all dimensions are required for every finish. The document serves as a standard for thread finish specifications by the ISBT-Thread Finish Review Sub-Committee.

Uploaded by

guillepaez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
13 views1 page

34 (TFRSC Nomenclature) Nomencard

The document outlines the TFRSC nomenclature for thread finish specifications, detailing various dimensions and points relevant to construction and inspection, such as tamper evident bead diameter and thread root diameter. It includes reference dimensions and indicates that not all dimensions are required for every finish. The document serves as a standard for thread finish specifications by the ISBT-Thread Finish Review Sub-Committee.

Uploaded by

guillepaez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TFRSC Nomenclature www.threadspecs.

com

TFRSC Nomenclature
A– Tamper evident bead diameter
B– Tamper evident band recess diameter
ß– Helix angle at pitch diameter
C– Control diameter at TOF
D– Tamper evident bead height measured from TOF to gauge pt
GAUGE PT
A point which may be required for
E– Thread root diameter
construction or inspection F– Upper ring diameter
INT PT G– Lower ring diameter
Intersection point
TAN PT
H– Clearance height required for proper closure function
Tangency point I– Minimum diameter through finish
CONSTRUCTION J– Height from TOF to the top of the tamper evident bead
Dimension provided for creation of
geometry and not for inspection K– Height from TOF to the gauge pt at the start of full thread
( )
(at thread start position)
Reference dimensions are shown in L– Height From TOF to top of bead
parentheses
M– Construction gauge pt on support ledge
P– Thread pitch (measured from K)
All dimensions are not necessarily
required or measured on some finishes PL – Parting-line
PLK– Height from TOF to the gauge pt of first full thread taken at
parting-line (clockwise from thread start position)
S– Height from TOF to start of full depth of thread
T– Thread crest diameter
TOF – Top of finish
V– Control diameter depth
W– Width of bead
X– Height from TOF to bottom of support ledge
Y– Seal control length
Z– Maximum diameter on support ledge

www.threadspecs.com
©2000 TFRSC

©2000 TFRSC
[email protected]
(+001) (905) 951-5000 ext.3552
ISBT–Thread Finish Review Sub-Committee
Voluntary Standard Thread Finish Specifications

You might also like