PENETRON ADMIX® SB

CRYSTALLINE WATERPROOFING AND DURABILITY ADMIXTURE

DESCRIPTION DIRECTIONS FOR USE

PENETRON ADMIX® SB (Soluble Bag integral Dosage rate:
crystalline waterproofing and durability admix) is
PENETRON ADMIX ® SB is designed to be dosed at the rate of one soluble bag
added to the concrete mix at the time of batching.
per cubic yard (or cubic meter) of concrete. For most mix designs in use, this
PENETRON ADMIX® SB’s various active,
falls within the range of acceptability of 1% by weight of cementing materials.
proprietary chemicals react with the moisture in
Consult with Penetron’s Technical Department for assistance in verifying the
fresh concrete and with the by-products of cement
appropriate dosage rate and for further information regarding enhanced
hydration to cause a catalytic reaction generating
chemical resistance and optimum concrete performance for your project.
a non-soluble crystalline formation throughout the
pores and capillary tracts of the concrete. Thus, Mixing:
the concrete becomes permanently sealed against PENETRON ADMIX® SB must be added to the concrete at the time of batching.
the penetration of water or liquids from any
direction. However, PENETRON ADMIX® SB treated The sequence of procedures for addition will vary according to the type of
concrete will still allow the passage of vapor batch plant operation and equipment. The following are some typical mixing
through the structure (i.e. the concrete will be able guidelines. For more detailed information on dosing procedures, contact
to “breathe”). Even after the concrete has cured, your Penetron representative.
PENETRON ADMIX® SB remains dormant in the Ready mix plant - Dry batch operation: Add PENETRON ADMIX® SB directly
concrete and will reactivate in the presence of into the drum of the ready-mix truck and immediately before charging the
moisture to seal capillary tracts and hairline drum with 60%-70% of the required mix water, along with 300-500 lb (136-227 kg)
cracks. The concrete is also protected from of aggregate. Mix the materials for 2-3 minutes to ensure the PENETRON
deterioration due to harsh environmental ADMIX® SB is distributed evenly throughout the mix water. Add the balance of
conditions. materials to the ready-mix truck in accordance with standard batching
PENETRON ADMIX® SB has been specially practices.
formulated to meet varying project and tempera Ready mix plant - Central mix operation: Ideally, PENETRON ADMIX® SB
ture conditions (see Setting time and strength). should be added directly into the central mix drum before all other ingredi-
Consult with a Penetron technical representative ents. However, when this is impractical or unsafe, PENETRON ADMIX® SB can
for additional detailed support on your project. be added directly into the drum of the ready-mix truck immediately before
charging with concrete. The dosed concrete should be allowed to mix in
APPLICATIONS accordance with ACI guidelines or for a minimum of 70 revolutions at
Reservoirs standard mixing speeds (approximately 5 minutes) to ensure even distribution
of PENETRON ADMIX® SB throughout the concrete.
Sewage and water treatment plants
Precast batch plant: Consult with a Penetron technical representative to
Secondary containment structures determine if PENETRON ADMIX® SB would suit your precast batch plant
Tunnels and subway systems operation or if one of our other packaging solutions may be more appropriate.
Underground vaults NOTE: It is important to obtain a homogeneous mixture of PENETRON ADMIX® SB
with the concrete. To avoid clumping and improve thorough dispersion,
Foundations
Penetron Admix should not be added to wet concrete. Please contact your
Parking structures Penetron Technical Representative for additional project specific guidelines
Swimming pools should none of above recommended dosing methods not be implementable.
For further information regarding the proper use of PENETRON ADMIX® SB
Precast, cast-in-place and shotcrete applications for a specific project, consult with a Penetron technical representative.

TOTAL CONCRETE PROTECTION® Page 1

 PENETRON ADMIX® SB

Setting time and strength: ADVANTAGES

The setting time of concrete is affected by the chemical and physical Resists extreme hydrostatic pressure from either
composition of ingredients, temperature of the concrete and climatic conditions. positive or negative surface of the concrete element
Retardation of set may occur when using PENETRON ADMIX® SB. The amount Becomes an integral part of the concrete
of retardation will depend upon the concrete mix design and the dosage rate of Highly resistant to aggressive chemicals
PENETRON ADMIX® SB. However, under normal conditions, PENETRON ADMIX® SB Seals hairline cracks up to 1/51” (0.5 mm)
will provide a normal set concrete. Concrete containing PENETRON ADMIX® SB
Allows concrete to breathe
may develop higher ultimate strengths than plain concrete. Trial mixes should
be carried out under project conditions to determine setting time and strength Non-toxic (NSF 61 certified for potable water
of the concrete. applications)
Less expensive than traditional methods
Concrete treated with PENETRON ADMIX® SB should be placed and finished in
Permanent
accordance with good concrete practices. ACI guidelines and recommendations
should be observed. Added to the concrete at the time of batching and
therefore not subject to climatic restraints
SPECIAL CONSIDERATIONS Reduces construction scheduling time
When incorporating PENETRON ADMIX® SB, the temperature of the concrete Improves durability of concrete
mix should be above 40ºF (4ºC). Permeability Reducing Admixture for Hydrostatic
conditions (PRAH)
PACKAGING Zero VOC – PENETRON powdered products contain
zero volatile organic compounds and are safe for
PENETRON ADMIX® SB is available in 6.6-lb (3-kg) soluble bags, packed 6 bags
use both outdoors and in confined indoor spaces
to a plastic pail. For large projects, customized packaging is available.
Exceeds requirements of ASTM C494-S (Specific
STORAGE / SHELF LIFE Performance Admixtures)
A non-toxic, non-staining green tracer in the
PENETRON products must be stored dry at a minimum temperature of 45ºF
bleed water during concrete placement and
(7ºC). Shelf life is 24 months when stored under proper conditions.
curing visually confirms the addition of Penetron
TECHNICAL SERVICES Admix® SB

For more detailed instructions, alternative application methods, or information

concerning the compatibility of the PENETRON treatment with other products
or technologies, contact the Penetron Technical Department or your local 004aCPR2013-07-10
Penetron representative. EN 934-2
Penetron International, Ltd.
601 South Tenth Street, Unit 300
SAFE HANDLING INFORMATION Allentown, PA 18103
PENETRON ADMIX® SB is alkaline. As a cementitious powder or mixture, 08
PENETRON ADMIX® SB may cause significant skin and eye irritation. Directions PENETRON ADMIX
for treating these problems are clearly detailed on all Penetron pails and Crystalline Capillary Admixture
Water Resisting Admixture
packaging. Penetron International, Ltd. also maintains comprehensive and
up-to-date Safety Data Sheets on all its products. Each sheet contains health Chloride content: < 0,10 % by mass
and safety information for the protection of your employees and customers. Alkali content: < 10,3 % by mass
KEEP OUT OF REACH OF CHILDREN. Compressive strength: ≥ 85 % of control
Conventional dry material content: ≥ 97,0 %
Contact Penetron International, Ltd. or your local Penetron representative to Air content in fresh concrete: ≤ 2 % by volume
obtain copies of Safety Data Sheets prior to product storage or use. Capillary Absorption (after 90 day curing): ≤ 60 % by mass
WARRANTY: PENETRON INTERNATIONAL, LTD. warrants that the products manufactured by
it shall be free from material defects and will conform to formulation standards and contain all
components in their proper proportion. Should any of the products be proven defective, the
liability to PENETRON INTERNATIONAL, LTD. shall be limited to replacement of the material
proven to be defective, and PENETRON INTERNATIONAL, LTD. shall in no case be liable
otherwise or for incidental or consequential damages. PENETRON INTERNATIONAL, LTD. MAKES NO
WARRANTY AS TO MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AND THIS WARRANTY IS
IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED. User shall determine the suitability of
the product for its intended use and assume all risks and liability in connection therewith.

PENETRON INTERNATIONAL, LTD.

601 S. 10th Street, Unit 300, Allentown, PA 18103
(631) 941-9700 • [email protected] • penetron.com www.

TOTAL CONCRETE PROTECTION® v. P03 Page 2