Test Report
Test Report
Test Standards:
FCC PART 15B
Sample Description
Product Type: Amateur Radio
Model No.: UV-17R
Multiple Model: BF-17R
Trade Mark: BAOFENG, POFUNG
Date Received: 2022-07-28
Date of Test: 2022-12-18 to 2022-12-19
Report Date: 2022-12-23
* In the configuration tested, the EUT complied with the standards above.
Prepared and Checked By: Approved By:
Zeki Ma Candy Li
EMC Engineer EMC Engineer
Note: This report may contain data that are not covered by the A2LA accreditation and are marked with an asterisk “★”.
Shenzhen Accurate Technology Co., Ltd. is not responsible for the authenticity of any test data provided by the applicant. Data included from the applicant
that may affect test results are marked with an asterisk ’*’. Customer model name, addresses, names, trademarks etc. are not considered data.
This report cannot be reproduced except in full, without prior written approval of the Company. Unless otherwise stated the results shown in this test report
refer only to the sample(s) tested. This report is valid only with a valid digital signature. The digital signature may be available only under the Adobe software
above version 7.0.
TABLE OF CONTENTS
DOCUMENT REVISION HISTORY .........................................................................................................................3
GENERAL INFORMATION .......................................................................................................................................4
PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) .....................................................................................4
OBJECTIVE ...................................................................................................................................................................4
TEST METHODOLOGY ..................................................................................................................................................4
MEASUREMENT UNCERTAINTY ....................................................................................................................................5
TEST FACILITY .............................................................................................................................................................5
SYSTEM TEST CONFIGURATION ..........................................................................................................................6
JUSTIFICATION .............................................................................................................................................................6
EUT EXERCISE SOFTWARE ..........................................................................................................................................6
SPECIAL ACCESSORIES .................................................................................................................................................6
EQUIPMENT MODIFICATIONS .......................................................................................................................................6
SUPPORT EQUIPMENT LIST AND DETAILS ....................................................................................................................6
BLOCK DIAGRAM OF RADIATED TEST SETUP...............................................................................................................7
SUMMARY OF TEST RESULTS ...............................................................................................................................9
TEST EQUIPMENT LIST ......................................................................................................................................... 10
FCC §15.107 – CONDUCTED EMISSIONS ............................................................................................................ 11
APPLICABLE STANDARD ............................................................................................................................................ 11
EUT SETUP ................................................................................................................................................................ 11
EMI TEST RECEIVER SETUP ....................................................................................................................................... 11
TEST PROCEDURE ...................................................................................................................................................... 12
FACTOR & OVER LIMIT CALCULATION ...................................................................................................................... 12
TEST DATA ................................................................................................................................................................ 12
FCC §15.109 - RADIATED EMISSIONS ................................................................................................................. 15
APPLICABLE STANDARD ............................................................................................................................................ 15
EUT SETUP ................................................................................................................................................................ 15
EMI TEST RECEIVER & SPECTRUM ANALYZER SETUP .............................................................................................. 16
TEST PROCEDURE ...................................................................................................................................................... 16
FACTOR & OVER LIMIT CALCULATION ...................................................................................................................... 16
TEST DATA ................................................................................................................................................................ 17
FCC §15.111 - ANTENNA CONDUCTED POWER FOR RECEIVERS .............................................................. 38
APPLICABLE STANDARD ............................................................................................................................................ 38
EUT SETUP ................................................................................................................................................................ 38
TEST PROCEDURE ...................................................................................................................................................... 38
TEST DATA ................................................................................................................................................................ 38
Date of
Revision Number Report Number Description of Revision
Revision
0 XMTN1220728-34315E-EM-00B Original Report 2022-12-23
GENERAL INFORMATION
Product Description for Equipment under Test (EUT)
Objective
This report is in accordance with Part 2-Subpart J, and Part 15-Subparts A and B of the Federal
Communication Commission’s rules.
The objective of the manufacturer is to determine the compliance of EUT with FCC Part 15, Class B
device.
Test Methodology
All measurements contained in this report were conducted with ANSI C63.4-2014, American National
Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and
Electronic Equipment in the range of 9 kHz to 40 GHz.
All radiated and conducted emissions measurement was performed at Shenzhen Accurate Technology Co.,
Ltd. The radiated testing was performed at an antenna-to-EUT distance of 3 meters.
Measurement Uncertainty
Parameter Uncertainty
Occupied Channel Bandwidth 5%
RF Frequency 0.082*10-7
RF output power, conducted 0.73dB
Unwanted Emission, conducted 1.6dB
AC Power Lines Conducted Emissions 2.72dB
9kHz - 30MHz 2.66dB
Emissions,
30MHz - 1GHz 4.28dB
Radiated
1GHz - 18GHz 4.98dB
Temperature 1℃
Humidity 6%
Supply voltages 0.4%
Note: The extended uncertainty given in this report is obtained by combining the standard uncertainty times the
coverage factor K with the 95% confidence interval. Otherwise required by the applicant or Product Regulations,
Decision Rule in this report did not consider the uncertainty.
Test Facility
The test site used by Shenzhen Accurate Technology Co., Ltd. to collect test data is located on the 1/F., Building
A, Changyuan New Material Port, Science & Industry Park, Nanshan District, Shenzhen, Guangdong, P.R.
China.
The test site has been approved by the FCC under the KDB 974614 D01 and is listed in the FCC Public Access
Link (PAL) database, FCC Registration No.: 708358, the FCC Designation No.: CN1189.
Accredited by American Association for Laboratory Accreditation (A2LA) The Certificate Number is 4297.01.
Listed by Innovation, Science and Economic Development Canada (ISEDC), the Registration Number is
5077A.
Justification
The system was configured for testing in a typical fashion (as normally used by a typical user).
NOAA Channel:
Frequency Frequency
Channel Channel
(MHz) (MHz)
1 162.5500 5 162.4500
2 162.4000 6 162.5000
3 162.4750 7 162.5250
4 162.4250 / /
No exercise software.
Special Accessories
Equipment Modifications
EUT 10cm
Receptacle
1.0 Meter
Non-Conductive Table
80 cm above Ground Plane
Earphone
1.5 Meters
Test Mode1:
AC Mains
Adapter
EUT
10cm
Receptacle
1.0 Meter
Non-Conductive Table
80 cm above Ground Plane
Earphone
1.5 Meters
EUT
Non-Conductive
Non-Conductive Table
Table
80
80 cm
cm above
above Ground
Ground Plane
Plane Earphone
1.5 Meters
Calibration Calibration
Manufacturer Description Model Serial Number
Date Due Date
Conducted emission
Rohde & Schwarz EMI Test Receiver ESCI 100784 2022/11/25 2023/11/24
Rohde & Schwarz L.I.S.N. ENV216 101314 2022/11/25 2023/11/24
Anritsu Corp 50 Coaxial Switch MP59B 6100237248 2022/12/07 2023/12/06
Unknown RF Coaxial Cable No.17 N0350 2022/11/25 2023/11/24
Conducted Emission Test Software: e3 19821b (V9)
Radiated Emissions Test
Rohde & Schwarz Test Receiver ESR 102725 2022/11/25 2023/11/24
Rohde & Schwarz Spectrum Analyzer FSV40 101949 2022/11/25 2023/11/24
A.H. Systems, inc. Preamplifier PAM-0118P 135 2022/11/08 2023/11/07
SONOMA
Amplifier 310 N 186131 2022/11/08 2023/11/07
INSTRUMENT
Schwarzbeck Bilog Antenna VULB9163 9163-323 2021/07/06 2024/07/05
Schwarzbeck Horn Antenna BBHA9120D 9120D-1067 2020/01/05 2023/01/04
Vector Signal
AGILENT N5182A MY50143401 2022/10/24 2023/10/23
Generator
Unknown RF Coaxial Cable No.10 N050 2022/11/25 2023/11/24
Unknown RF Coaxial Cable No.11 N1000 2022/11/25 2023/11/24
Unknown RF Coaxial Cable No.12 N040 2022/11/25 2023/11/24
Unknown RF Coaxial Cable No.13 N300 2022/11/25 2023/11/24
Unknown RF Coaxial Cable No.14 N800 2022/11/25 2023/11/24
Radiated Emission Test Software: e3 19821b(V9)
RF Conducted Test
Rohde & Schwarz Spectrum Analyzer FSV-40 101495 2022/11/25 2023/11/24
Unknown RF Coaxial Cable No.33 RF-03 Each time
* Statement of Traceability: Shenzhen Accurate Technology Co., Ltd. attests that all calibrations have been
performed in accordance to requirements that traceable to National Primary Standards and International System of
Units (SI).
According to FCC§15.107
EUT Setup
The measurement procedure of EUT setup is according with ANSI C63.4-2014. The related limit was
specified in FCC Part 15.107 Class B.
The external I/O cables were draped along the test table and formed a bundle 30 to 40 cm long in the
middle.
During the conducted emission test, the EMI test receiver was set with the following configurations:
Test Procedure
Maximizing procedure was performed on the six (6) highest emissions of the EUT.
All final data was recorded in the Quasi-peak and average detection mode.
The “Over limit” column of the following data tables indicates the degree of compliance with the applicable
limit. For example, an Over limit of -7 dB means the emission is 7 dB below the limit. The equation for
calculation is as follows:
Test Data
Environmental Conditions
Temperature: 21 ℃
Relative Humidity: 54 %
ATM Pressure: 101kPa
AC 120V/60Hz, Line:
AC 120V/60Hz, Neutral:
FCC §15.109
EUT Setup
Below 1GHz:
Above 1GHz:
The radiated emission tests were performed in the 3 meters chamber test site, using the setup accordance
with the ANSI C63.4-2014. The specification used was the FCC Part 15.109 Class B limits.
The external I/O cables were draped along the test table and formed a bundle 30 to 40 cm long in the
middle.
During the radiated emission test, the EMI test receiver & Spectrum Analyzer Setup were set with the
following configurations:
All data was recorded in the Quasi-peak detector mode from 30 MHz to 1 GHz, Peak and average
detection mode above 1 GHz.
If the maximized peak measured value complies with the limit, then it is unnecessary to perform
QP/Average measurement.
Test Procedure
Maximizing procedure was performed on the highest emissions to ensure that the EUT complied with all
installation combinations.
The “Over Limit” column of the following data tables indicates the degree of compliance with the applicable
limit. For example, a margin of -7dB means the emission is 7dB below the limit. The equation for margin
calculation is as follows:
Test Data
Environmental Conditions
Temperature: 21℃
Relative Humidity: 55%
ATM Pressure: 101kPa
Note: Pre-scan in the X, Y and Z axes of orientation, the worst case Y-axis of orientation was recorded.
30MHz-1GHz:
Test mode 1: Charging
Horizontal:
Vertical
Horizontal:
Vertical
Horizontal:
Vertical
Horizontal:
Vertical
Horizontal:
Vertical
Note: For below 1GHz, when the test result of peak was 6dB below to the limit of QP, just peak value was recorded.
Above 1 GHz:
Test mode 1: Charging
Horizontal:
Vertical
Horizontal:
Vertical
Horizontal:
Vertical
Horizontal:
Vertical
Horizontal:
Vertical
FCC §15.111
Limit
The antenna conducted power of the receiver as defined in §15.111 shall not exceed the values given in the following
tables
EUT Setup
Test Procedure
1. The receiver antenna terminal connected to a spectrum analyzer.
2. The test data of the worst case condition was reported on the following Data page.
Test Data
Environmental Conditions
Temperature: 25 ℃
Relative Humidity: 52 %
ATM Pressure: 101kPa
Test mode 2:
Test mode 3:
Test mode 4:
Test mode 5:
*****END OF REPORT*****