Microprocessors and Interfacing Devices 3
Microprocessors and Interfacing Devices 3
www.android.previousquestionpapers.com JJ JJ
| www.previousquestionpapers.com JJ JJ JJ
| www.ios.previousquestionpapers.com
JJ JJ JJ JJ
Note: This question paper contains two parts A and B.
JJ JJ JJ
Part A is compulsory which carries 25 marks. Answer all questions in Part A. Part B
JJ
consists of 5 Units. Answer any one full question from each unit.
Each question carries 10 marks and may have a, b, c as sub questions.
PART - A
JJ JJ JJ JJ JJ JJ JJ
(25 Marks) JJ
1.a) What is meant by Memory segmentation? [2]
b) Name the special purpose registers and write the function of each register. [3]
c) Give the CALL instruction operation. [2]
d) Name different types of assembler directives, explain any two. [3]
JJ JJ
e) JJ JJ
Define interrupt service routine. JJ JJ JJ [2] JJ
f) Compare Static and Dynamic memories. [3]
g) Define prototype. [2]
JJ
h)
i)
j)
JJ P
Explain the serial data transfer schemes operation.
Compare microprocessor and microcontroller.
Q
List different instruction set groups of 8051 µc.
JJ JJ JJ JJ JJ
[3]
[2]
[3]
JJ
JJ
2.a)
b)
JJ JJ JJ
P PART - B
JJ[5+5] JJ
OR
3.a) Explain the Register set of 8086 processor.
b) Write short note on interrupt structure of 8086. [5+5]
JJ JJDraw
6.a)
b)
JJ of 8086 interrupt
the structure JJ vector table JJand explain.JJ
Explain the significance of cascading 8259 controller.
JJ[5+5] JJ
OR
7.a) Interface a typical 12-bit DAC with 8255 and write a program to generate a Square
waveform of period 10ms. The CPU run at 5 MHz clock frequency.
b) Explain why 8255 ports are divided into two groups? Discuss how these groups are
JJ JJ JJ JJ
controlled in different modes of operation? JJ JJ JJ
[5+5] JJ
8.a) Explain TTL to RS 232C and explain high speed serial communication standards and
JJ JJ
b)
USB.
JJ JJ JJ
Explain Asynchronous transmission in serial mode. JJ JJ [5+5] JJ
OR
9.a) Explain the line driver and the line receiver circuits of serial communication.
b) What do you mean by I/O mapped I/O? Draw the interfacing of 8251 with 8086 in I/O
mapped I/O mode. [5+5]
JJ JJ JJ JJ JJ
10.a) Explain various operation modes of Timer-1 and Timer-0.
JJ JJ JJ
b) Describe the Timer control (TCON) and Timer mode control (TMOD) registers. [5+5]
OR
11. Explain the various addressing modes of 8051 with suitable example. [10]
JJ JJ JJ JJ JJ JJ JJ JJ
--ooOoo--
JJ JJ JJ JJ JJ JJ JJ JJ
JJ JJ JJ JJ
Q P JJ JJ JJ JJ
JJ JJ JJ JJ
P JJ JJ JJ JJ
JJ JJ JJ JJ JJ JJ JJ JJ
JJ JJ JJ JJ JJ JJ JJ JJ
JJ JJ JJ JJ JJ JJ JJ JJ