INSTRUCTION

MANUAL
Land Rover 2-Seater
Ride-On with Remote
Ver. 1 SKY5271 + SKY5272 + SKY5273
 Charge for 12 hrs
before initial use.
After initial charge,
follow the normal
recommended
charging time.

bestchoiceproducts.com
 SAFETY Please retain these instructions for future reference.

This vehicle must be assembled by an adult who has read and understood the instructions in this manual.
Keep the packaging and bags away from children and dispose of all packaging before use. Always use
common sense and safe practices when operating this vehicle. This product contains or emits chemicals
known in the state of California to cause cancer or birth defects or other reproductive harm.
NOTE: For best performance, only use this vehicle on flat and hard surfaces.
AGE RANGE: 3 to 8 years old
WEIGHT CAPACITY: 125 lbs. (combined)
The following safety hazards may result in serious injury or death:
• This product contains small parts. Keep children away during assembly. Make sure to remove all packaging
material and parts from underneath the vehicle body.
• Never open the battery. Batteries contain lead and lead compounds (acids) that are toxic and corrosive,
and known to the state of California to cause cancer and reproductive harm.
• Limbs, hair, and clothing can get caught in moving parts. Always wear shoes, keep limbs away from
moving parts, and do not wear loose clothing while operating this vehicle.
• This vehicle does not have brakes or braking capability. Do not leave a child unattended during operation.
Do not use this in a location that may require braking capability, as this could result in loss of control,
which may cause serious injury or death.
• Use of this vehicle near streets, motor vehicles, steps, bodies of water, sloped surfaces, hills, wet areas,
flammable vapors, in alleys, at night, or in the dark could result in an unexpected accident.
• Use of this vehicle in unsafe conditions such as snow, rain, loose dirt, mud, sand, or gravel may result in
an unexpected accident such as tipping over, and could damage the electrical system or battery.
• Do not operate this vehicle in an unsafe manner. Examples include but are not limited to:
- Pulling the vehicle with another vehicle or similar device
- Allowing more than two children to ride
- Pushing the user
- Traveling at an unsafe speed

BATTERY WARNINGS
The following safety hazards may result in serious injury or death:
• Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire
or explosion. Only use the supplied battery and charger.
• Use of the rechargeable battery and charger for any other product may result in overheating, fire,
or explosion. Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery in a well-ventilated area. Do not charge
the battery near heat or flammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct contact
between the terminals. Picking up the battery by the wires or charger can cause damage to the battery
and may result in a fire. Always pick up the battery by its case or handles.
• Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery and
keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury.
If contact or exposure occurs immediately call your physician. If the chemical is on the skin or in the eyes,
flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person water
or milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not
induce vomiting.
• Battery posts, terminals, and related accessories contain lead and lead compounds (acid) – chemicals
known to the State of California to cause cancer, reproductive harm, and are toxic and corrosive.
Never open the battery.
• Tampering or modifying the electric circuit system may cause a shock, fire or explosion and permanently
damage the system. Exposed wiring and circuitry in the charger may cause electric shock. Always keep
the charger housing closed.
|3
 WARNING
To reduce the risk of injury, adult supervision is required. Never use on roadways, near motor vehicles, on
or near steep inclines or steps, swimming pools or other bodies of water; always wear shoes, and never
allow more than two children in the vehicle at a time.
• Maximum of two children are allowed in the vehicle at a time.
• Never leave a child unattended.
• Always sit in the seat when using this vehicle.
• Keep your hands, hair, and clothes away from moving parts.
• Children under 3 years of age cannot use the vehicle.
• Only drive on level ground.
• Do not drive the vehicle into loose dirt, mud, sand, fine gravel, or on wet surfaces.

SPECIFICATIONS

Overall Dimensions 47.5"(L) x 33.5"(W) x 24.5"(H)

Weight 60 lbs.

Weight Capacity 125 lbs. (combined)

Age Range 3 – 8 years old

Speed Low: 1.8 mph., High: 3.7 mph.

Initial Charge Time 12 hours

Charging Time 8 – 12 hours

Run Time 1 – 2 hours

Battery Type 1 - Rechargeable SLA - 12V 7AH

Electric Motor Double drive: 12V

Charger Output: DC 12V

Material PP Plastic, Metal

4|
TOOLS REQUIRED

+ AAA - LBS
PHILLIPS PLASTIC 2 AAA BATTERIES
SCREWDRIVER WRENCH (FOR REMOTE) 125 LBS 2 PERSON APPROXIMATELY
(2, PROVIDED) CAPACITY ASSEMBLY 45 MIN.
(COMBINED) ASSEMBLY

HARDWARE

1 M4 x 12mm
SCREW
2 M4 x 10mm
SCREW

8 PCS 2 PCS

PARTS

A WHEEL B HUBCAP C STEERING WHEEL

4 PCS 4 PCS 1 PC

D REAR FRAME E SIDE FRAME (L/R) F SEAT

1 PC 1 SET 1 PC

|5
 PARTS

G BACKREST H WINDSHIELD I SIDE MIRRORS (L/R)

1 PC 1 PC 1 SET

J REMOTE CONTROL K 12V CHARGER

P S

1 PC 1 PC

PRODUCT ASSEMBLY
Flip vehicle over and lay it on a level surface. Remove all parts and packaging from within the

1 vehicle body.
NOTE: Parts are located in the compartment under the rear bracket.

6|
PRODUCT ASSEMBLY
Secure the rear bracket with four part 1 screws.

2 Remove the nuts and washers from the rear axle.

1 x4

3 Slide the gear boxes onto the rear axle.

NOTE: Make sure the rear axle is positioned evenly on the vehicle.

|7
 PRODUCT ASSEMBLY
Slide a part A wheel onto the rear axle, then secure it by replacing a nut and washer. Snap on a

4 part B hubcap. Repeat on the other side.

NOTE: Use two plastic wrenches (one on each side) and rotate in opposite directions to tighten nuts.

A x2

B x2

5 Remove two nuts and washers from the front axle.

NOTE: Leave two washers on the axle, one on each side.
Slide a part A wheel onto the front axle, then secure it by replacing a nut and washer. Snap on a
part B hubcap. Repeat on the other side.

A x2

B x2

8|
PRODUCT ASSEMBLY
Flip the car onto its wheels. Join the connector from the part C steering wheel to the

6 corresponding connector on the steering wheel mount.

Press the steering wheel into the mount until it locks in place.

7 Snap in the part D rear frame and secure it with two part 1 screws.
NOTE: Snap in the back of the rear frame and then the front.

1 x2

|9
 PRODUCT ASSEMBLY
Snap in the part E side frame set (L/R).

8 E

RIGHT LEFT

9 Within the seat, connect the red wire to the red terminal on the battery.

Remove
co
v
er
on
terminal

10 |
PRODUCT ASSEMBLY
Insert the tabs on the part F seat into the designated slots and secure with two part 1 screws.

10 Slide the part G backrest into the back of the seat until it locks in place.
NOTE: Make sure to clear seatbelts out of the way during installation.

1 x2
F

11 Attach the part I side mirror set (L/R) to the part H windshield with two part 2 screws.
Snap the windshield into the designated slots.

RIGHT I LEFT

2 x2

| 11
 CHARGING INSTRUCTIONS
• Charging port is located below the seat. Insert one end of the charger into the charging port and
plug the other end into a wall outlet.
• Charge the battery 12 hours before initial use.
• On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery
for more than 20 hours. Failure to charge the battery as directed could cause permanent damage
to the battery and void the warranty.
• Damage to the battery may occur if it is allowed to drain completely. Do not allow the battery to
drain completely.
• Check the battery and charger (supply cord, connector) for wear and damage before charging.
Do not charge the battery if damage has occurred.
• Only an adult who has read and understood the safety warnings should handle, charge and
recharge the battery.
HIGH SPEED

LOW SPEED

CHARGING
PORT

CARING FOR YOUR RIDE-ON

• Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
• Do not leave the vehicle in the sun for long periods of time or fading may occur. Store in shade or
cover with tarp.
• Do not wash the vehicle with a hose.
• Do not wash the vehicle with soap.
• Charge battery at least once a month to prolong the life of the battery.

12 |
 DASHBOARD DIAGRAM
• Push down on the pedal to drive forward/reverse. Release the pedal to slow down and stop.
• Lights: Turn headlights on/off
• Music: Cycle through music

MUSIC HORN LIGHTS MEDIA PLAYER FORWARD/PARK/

REVERSE

LOW SPEED/HIGH SPEED;

CHARGING PORT

PEDAL POWER SWITCH

MEDIA PLAYER
NOTE: By default, buttons play music included with the vehicle. Press and hold buttons for
secondary function.
• USB Port: Play music from a USB drive
• MicroSD (TF) Port: Play music from a MicroSD card
• AUX Input: Use AUX cable to plug in a music player to play music
• Mode: Press to toggle between music and FM radio

NEXT TRACK/
INCREASE VOLUME

PLAY/PAUSE TRACK MODE

USB PORT

MICROSD
PREVIOUS TRACK/ (TF) PORT
DECREASE VOLUME
AUX INPUT

| 13
 REMOTE CONTROL DIAGRAM

FREQUENCY KEY

FORWARD TURN LEFT

TURN RIGHT
BRAKE/PARK P S
SPEED INDICATOR
REVERSE LIGHTS

SPEED SELECT

• Install 2 AAA batteries into the remote control.

• After 10 seconds of non-operation, the remote will go into power-saving mode.

Linking the remote control:

1. Press and hold the frequency key for 2-4 seconds. The speed indicator light will flash.
2. Turn the vehicle on. The speed indicator light will turn solid to indicate a successful link.
3. If the speed indicator light continues to flash (indicating an unsuccessful link), remove and reinsert
the batteries and repeat steps 1 and 2.

FEATURES
• Compress switch to open door
• Extra storage in the hood
• Convenient handle to transport car

CALIFORNIA PROPOSITION 65
WARNING: Battery posts, terminals, and related accessories can expose you to chemicals including
lead and lead compounds, which are known to the State of California to cause cancer and birth defects or
other reproductive harm, and are toxic and corrosive. Wash hands after handling. For more information go
to www.P65Warnings.ca.gov

14 |
 TROUBLESHOOTING
PROBLEM REASON SOLUTION
Low battery Fully charge the battery
Electrical protection Stop use for several minutes and restart
Vehicle does not move
Switch not in the correct position Completely press in switches
Battery connectors disconnected Plug in battery connectors
Battery connectors disconnected Plug in battery connectors
Battery does not recharge Charger not connected
Completely plug in the charger
to socket or outlet

Battery does not last Battery does not have a full charge Fully charge the battery

Battery is warm and

makes a slight noise Normal Normal
while charging

Low battery Fully charge the battery

Slow speed Overloaded vehicle Reduce the weight on the vehicle
Uneven or sloped road Drive on flat pavement

Vehicles shakes Loose connection to motor

Ensure the motor is properly
while driving connected to the battery

Difficulty shifting between Attempting to shift while

Only shift when the vehicle is at a stop
forward/reverse vehicle in motion

Steering wheel is not Properly connect the steering

Vehicle is silent
properly connected wheel connector

FCC COMPLIANCE STATEMENT

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This product may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Responsible party (contact for FCC matters only):
Quality Control Dept.
5642 Ontario Mills Parkway
Ontario, CA 91764 | 15
 HELP CENTER

Question about your product? We're here to help. Visit us at:

help.bestchoiceproducts.com

CHAT
US!

Chat Support Product Inquiry Orders FAQ Product Assembly Returns & Refunds

PRODUCT WARRANTY INFORMATION

All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long
as the item is returned in its original product packaging and all accessories from its original shipment are
included. All returned items will receive a full refund back to the original payment method. All returned
items will not be charged a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best
Choice Products Customer Service Representative when the return request is submitted. Items received
without an RA may not be accepted or may increase your return processing time. Once an item has been
received by Best Choice Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If
the reason for return is a result of an error by Best Choice Products then Best Choice Products will provide
a pre-paid shipping label via email. Boxes for return shipping will not be provided by Best Choice Products,
and is the customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items
returned are not considered undamaged until they are received by Best Choice Products and verified as
such. All damages to items are the customer’s responsibility until the item has been received by and
acknowledge by Best Choice Products as undamaged.

WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or
loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.