CMT2189B
CMT2189B
240 - 960 MHz FLASH Based OOK Transmitting Wireless MCU
MCU Features SoCRF Features
PIC16 compatible instruction set Frequency range: 240 - 960 MHz
Up to 16 MHz clock operating frequency Modulation mode: OOK
2T or 4T instruction cycle Data rate: 1.0 - 40.0 kbps
8-layer hardware stack x 11 bit Output power: + 13 dBm
2 k x 14 b rewritable program storage space (16 Operating current: 17.5 mA @+13dBm, 433.92 MHz with
bytes/page) continuous 1 transmitting
256 x 8 b data EEPROM (16 bytes/page)
128 x 8 b SRAM
Support of online debug
System Features
Support of ICSP programming Supply voltage：2.0 ~ 3.6 V
Support of data EEPROM programming in application Operating temperature: -4 0 ~ + 85 ℃
8 general IOs SOP14 packaging
One Timer 0 with 8-bit prescaler
One Timer 2 with 8-bit prescaler
WDT with 7-bit prescaler (the overflow frequency is
about 16 - 2048 ms)
Application
Support of power up delay counter PWRT Wireless weather forecasting system
Support of low power mode SLEEP
Wireless lighting control system
Multiple wakeup sources: INT, port change interrupt,
Consumer remote control.
WDT, data EEPROM write operation completion, etc.
Built-in high speed 16 MHz RC oscillator
Built-in low speed 32 kHz RC oscillator
Port change interrupt: RA0 - RA7
Program space protection
Description
Embedded with 8-bit RISC core, the CMT2189B is an OOK
based transmitting wireless MCU with low power and low cost,
applying to 240 - 960 MHz band wireless applications.
Empowered by a 2 k x 14 b rewritable program space, a
high-efficiency and ultra-low power transmitter, along with the
supports of up to 8 general-purpose IOs, online debug, and
ultra-low power sleep mode, the chip is ideal for a variety of
consumer remote control applications. With an operating
temperature range of - 40 ~ 85 ℃ and a power supply
voltage of 2.0 ~ 3.6 V, it consumes only a current of 17.5 mA
while delivering +13 dBm power at 433.92 MHz. The
CMT2189B co-working with CMOSTEK's NextGenRFTM
series receivers offers an ideal solution for ultra-low power
RF applications..
CMT2189B PIN Arrangement
Copyright © By CMOSTEK Rev 0.9 | 1/5 www.cmostek.com
CMT2189B
Typical Application
Figure 1. CMT2189B typical Application Schematic (low cost matching network)
Rev 0.9 | 2/5 www.cmostek.com
CMT2189B
Table 1. Typical Application BOM (low cost matching network)
Component Value Component Value
Label Description Unit Supplier
@ 315 MHz @ 433.92 MHz
CMT2189B, 240-960 MHz FLASH
U1 - - - CMOSTEK
based OOK transmitting wireless MCU
X1 ± 20 ppm, SMD32 * 25 mm, crystal 26.25 26.2982 MHz EPSON
L1 ± 10%, 0603 multilayer chip inductor 220 180 nH Sunlord LQG18
L2 ± 10%, 0603 multilayer chip inductor 33 27 nH Sunlord LQG18
C1 ± 0.25 pF, 0603 NP0, 50 V 82 68 pF -
C2 ± 0.25 pF, 0603 NP0, 50 V 2 NC pF -
C3 ± 0.25 pF, 0603 NP0, 50 V NC 2.2 pF -
C4 ± 20%, 0603, NP0, 50 V 470 pF -
C5 ± 20%, 0603, X7R, 25 V 0.1 uF -
C6 ± 20%, 0603, X7R, 25 V 0.1 uF -
R1 - 10 Ω -
R2 - 10 Ω -
Table 2. CMT2189B Pin Description
Pin # Pin Name I/O Description
1 DVDD I 2 - 3.6 V digital power supply input pin.
2, 3 PC6, PC4 IO Port C I/O.
Crystal input pin, connecting the crystal (with the corresponding frequency
4 XTAL I
value and load capacitance of 15 pF) to GND.
RF serial port function with internal pull-up resistor. Pull down the pin through
5 RFCTRL IO
PC port or PA port to enable the function.
6 AVDD I 2 - 3.6 V analog power supply input pin.
7 GND I Chip ground.
8 RFO O RF output pin.
9-11 PA4- PA2 IO GPIO with IOC and WPU. It can configure pull-up resistor.
PA0 IO GPIO with IOC and WPU. It can configure pull-up resistor.
12
ICSPLCK I Clock signal for debug and programming series port (F max = 6 MHz).
PA1 IO GPIO with IOC and WPU. It can configure pull-up resistor.
13
ICSPDAT I Data signal for debug and programming series port (F max = 6 MHz).
14 PA7 IO GPIO with IOC and WPU. It can configure pull-up resistor.
Notes:
1. MCU programming interface: ICSPLCK, ICSPDAT, VDD-MCU and GND.
2. IOC = Interrupt On Change. WPU = Weak Pull Up.
Rev 0.9 | 3/5 www.cmostek.com
CMT2189B
Packaging Information
The packaging information of the CMT2189B is shown in the below figure.
Figure 2. SOP14 Packaging
Table 3. SOP14 Packaging Scale
Scale (mm)
Symbol
Min. Typ. Min.
A - - 1.75
A1 0.05 - 0.225
A2 1.30 1.40 1.50
A3 0.60 0.65 0.70
b 0.39 - 0.48
c 0.21 - 0.26
D 8.45 8.65 8.85
E 5.80 6.00 6.20
E1 3.70 3.90 4.10
e 1.27 BSC
h 0.25 - 0.50
L 0.50 - 0.80
L1 1.05 BSC
θ 0 - 8°
Rev 0.9 | 4/5 www.cmostek.com
CMT2189B
Contacts
CMOSTEK Microelectronics Co., Ltd. Shenzhen Branch
Address: 2/F Building 3, Pingshan Private Enterprise S.T. Park, Xili, Nanshan District, Shenzhen, Guangdong, China
Tel: +86-755-83231427
Post Code: 518057
Sales: [email protected]
Supports: [email protected]
Website: www.cmostek.com
Copyright. CMOSTEK Microelectronics Co., Ltd. All rights are reserved.
The information furnished by CMOSTEK is believed to be accurate and reliable. However, no responsibility is assumed for
inaccuracies and specifications within this document are subject to change without notice. The material contained herein is
the exclusive property of CMOSTEK and shall not be distributed, reproduced, or disclosed in whole or in part without prior
written permission of CMOSTEK. CMOSTEK products are not authorized for use as critical components in life support
devices or systems without express written approval of CMOSTEK. The CMOSTEK logo is a registered trademark of
CMOSTEK Microelectronics Co., Ltd. All other names are the property of their respective owners.
Rev 0.9 | 5/5 www.cmostek.com
