This vehicle is not designed to be used in conjunction with child
safety seat.
Do not use or install child safety seat in any seat or position in
the vehicle.
Always obey and follow laws and regulations regarding the
transportation of children.
Children that require the use of a child safety seat in a regular type
automobile should not be transported in this vehicle.
Foreword
Inspect battery terminals, cables and batteries before each use.
Always wear a full face shield, rubber gloves and rubber apron when
working with or in close proximity to batteries.
Turn the ignition switch to the off position, remove the key, set the park
brake, unplug the charger and place the run/tow switch to the tow
position before inspecting or performing any type of service on the
vehicle.
Connections should be tight and free of corrosion.
Utilize insulated tools only when working with electrical connections.
The tightness of the battery terminal nut should be between 95-105 inch
pounds of torque. Do not over tighten. Loose and/or over tightened
connections can cause battery failure, explosion and or fire.
Do Not Overfill the Batteries and keep batteries clean and free of
moisture.
If any high heat condition or burning smell is noticed immediately park
the vehicle in a safe location, place the ignition in the off position, move
yourself and passengers away quickly to a safe distance from the
vehicle and contact your dealer for assistance and repair. If fire or smoke
is detected contact your local fire department immediately. Do not store
your vehicle inside if any of these conditions exist.
Only use recommended batteries of the correct size.
When the light bar is at the top of indicator, the battery pack contains
a full charge.
When the battery discharge is down by 70%, the two remaining lights
will flick as a warning.
h
can be set by depressing the set buttons. This feature is especially useful
in measuring the distance between each charge cycle.
The reading of the speedometer can be programmed to read out in either
miles or ilometers. To change the display simply press and hold the small
button on the left.
Check if it is normal, if not, please contact your dealer for service.
Check if it is normal, if not, please contact your dealer for service.
5. After each use, the E-merge should be placed on charge. The batteries
should never be left discharged longer than absolutely necessary.
This vehicle is
equipped with a charger interlock feature. This feature prevents vehicle from
operating when the charger is connected to an AC power source.
circuit should
be between 100-240 volt and
, no longer than 100-feet (30m).
1. Always connect the charger to a GROUNDED outlet. When using
an extension cord, avoid excessive voltage drops by using a
grounded, 3-wire, 12-AWG cord no longer than 100 feet (30m).
each battery
1. For flooded lead-acid batteries, regularly check water levels of
each battery cell after charging and add distilled water as required
to level specified by battery manufacturer. Follow the maintenance
and safety instructions recommended by the battery manufacturer.
ONE : With respect to parts and labor against defects in material and
workmanship from date of delivery, all non-wear vehicle components including the batteries,
Solid State Controller, Vehicle frame, chassis, suspension (a-arms, shock absorbers, shock
mounts, and associated hardware), rack and pinion steering gearbox, transaxle, motor, and
charger are warranted for one year or 10,000 miles whichever occurs first, vehicles used in
Industrial, Commercial rentals and fleet type applications are warranted for a six month period or 5,000
miles whichever occurs first. Extended warranties are available. Please contact your dealer or visit
www.tomberlin.net for more information.
