Scribd
Upload
0 views2 pages

BPVC_VIII_1_26-1-2021

The document is a specification sheet for bellows expansion joints as per ASME Section VIII, Division 1, detailing various parameters such as item number, manufacturer, design pressures, temperatures, and material specifications. It includes sections for design movements, shell and bellows materials, and additional requirements for production approvals. The form is intended for use in the design and installation of pressure vessels and related components.

Uploaded by

whngomj
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0 views2 pages

BPVC_VIII_1_26-1-2021

The document is a specification sheet for bellows expansion joints as per ASME Section VIII, Division 1, detailing various parameters such as item number, manufacturer, design pressures, temperatures, and material specifications. It includes sections for design movements, shell and bellows materials, and additional requirements for production approvals. The form is intended for use in the design and installation of pressure vessels and related components.

Uploaded by

whngomj
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

FORM 26-1 SPECIFICATION SHEET FOR ASME SECTION VIII, DIVISION 1

MANDATORY APPENDIX 26 BELLOWS EXPANSION JOINTS

Date Applicable ASME Code Edition

1. Item Number Vessel Manufacturer

2. Drawing/Tag/Serial/Job Number Vessel Owner

3. Quantity Installation Location

4. Size O.D. I.D. in. Expansion Joint Overall Length in.

5. Internal Pressure: Design psig

6. External Pressure: Design psig

7. Vessel Manufacturer Hydrotest Pressure: Internal psig External psig

8. Temperature: Design Operating Upset ºF

9. Vessel Rating: MAWP MDMT Installed Position: Horiz. Vert.

10. Design Movements [Note (1)]:


Axial Compression (–) in. Axial Extension (+) in. Lateral in. Angular deg

11. Specified Number of Cycles

12. Design Torsion: Moment in.-lb or Twist Angle deg

13. Shell Material Bellows Material

14. Shell Thickness in. Shell Corrosion Allowance: Internal in. External in.

15. Shell Radiography: None Spot Full

16. End Preparation: Square Cut Outside Bevel Inside Bevel Double Bevel (Describe in Line 24 if special)

17. Heat Exchanger Tube Length Between Inner Tubesheet Faces in.

(07/19)
FORM 26-1 SPECIFICATION SHEET FOR ASME SECTION VIII, DIVISION 1
MANDATORY APPENDIX 26 BELLOWS EXPANSION JOINTS (Cont’d)

18. Maximum Bellows Spring Rate: N Y- lb/ in.

19. Internal Liner: N Y - Material

20. Drain Holes in Liner: N Y - Quantity/Size

21. Liner Flush With Shell I.D.: N Y - Telescoping Liners? N Y

22. External Cover: N Y - Material

23. Preproduction Approvals Required: N Y - Drawings / Bellows Calculations / Weld Procedures

24. Additional Requirements (e.g., bellows preset, ultrasonic inspection):

NOTE:
(1) For multiple movements, Design movements (line 10) can be replaced by operating movements, which should
then be described under “Additional Requirements” (line 24). For each one of them, axial compression or axial
extension, lateral deflection and angular rotation at each extremity of cycle, together with the specified number of
cycles, should be indicated. When known, the order of occurrence of the movements should also be indicated.

(07/21)

You might also like