Job No. Drawing Sheet of Rev.
Customer Date
Job By
Structure Approved
Calculation Title :
Data Set : (Note : all positions are measured in mm from the left-hand end of the beam)
Beam Properties : Section Type : My Beam
Bending stiffness, EI : 4,020.000 kNm²
Shear Stiffness, GA : 17,350.0 kN
Self-Weight, w : 0.2 kN/m (not included automatically in loading)
Overall length, L : 3,900.0 mm
Supports : Support No. Position (mm) Support Type (kN/mm)
S1 340.0 Knife-Edge -
S2 2,380.0 Knife-Edge -
Concentrated Loads : Load No. Position (mm) Magnitude (kN)
Distributed Loads : Load No.. Position (mm) Intensity (kN/m) Load Type
U1 0 - 3,900.0 1.4 - 1.4 Uniform
Point Values : (No Point Values Stored)
By using this Software you agree to the ARMDK Terms & Conditions of Use and associated limitations of liability detailed in the Menu (Help > About) 1
Job No. Drawing Sheet of Rev.
Customer Date
Job By
Structure Approved
Graphical Output :
0.0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 2.8 3.0 3.2 3.4 3.6 3.8 m
1.4 kN/m 1.4 kN/m
1.1 kN 4.2 kN
Bending Moment Diagram (kNm) Largest Positive Value = 0.1 kNm, Largest Negative Value = -1.6 kNm
-1.6
-0.1
0.0 +0.0
+0.1
Shear Force Diagram (kN) Largest Positive Value = 2.1 kN, Largest Negative Value = -2.1 kN
-2.1
-0.5
0.0 0.0
+0.7
+2.1
Deflection Diagram (mm) Largest Positive Value = 0.6 mm, Largest Negative Value = 0.0 mm
0.0 0.0
0.0
+0.0 +0.0
+0.6
By using this Software you agree to the ARMDK Terms & Conditions of Use and associated limitations of liability detailed in the Menu (Help > About) 2
