Scribd
Upload
679 views10 pages

Stator Slots and Coils

The document discusses stator slots and coils in electrical machines. It provides an example problem to determine the main dimensions, number of radial ventilating ducts, number of stator slots, and number of turns per phase of a 3.7 kW, 400 volt, 3 phase, 4 pole induction motor. It works through calculating these values and discusses winding details such as coil span needing to be odd for mush windings. The document also discusses the name plate of induction motors.

Uploaded by

usman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
679 views10 pages

Stator Slots and Coils

The document discusses stator slots and coils in electrical machines. It provides an example problem to determine the main dimensions, number of radial ventilating ducts, number of stator slots, and number of turns per phase of a 3.7 kW, 400 volt, 3 phase, 4 pole induction motor. It works through calculating these values and discusses winding details such as coil span needing to be odd for mush windings. The document also discusses the name plate of induction motors.

Uploaded by

usman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd

20 April 2017

Stator slots and coils

Dr. Irfan Ullah


Assistant Professor
Electrical Engineering Department
University of Management and technology

Electrical Machine Design EE424


Contents

1. Example
2. Name plate of induction motor
Example 10.1

Determine the main dimensions, number of radial ventilating ducts, number of


stator slots and the number of turns per phase of a 3.7 kW, 400 volts, 3 phase, 4
pole, 5 Hz squirrel cage induction motor to be started by a star delta stator.
Work out the winding details.
Assume:
Average flux density in the gap = 0.45 Wb/m2
Ampere conductor per meter = 23000
Efficiency = 0.85
Power factor = 0.84
Machines rated at 3.7 kW =, 4 poles are sold at competitive price and therefore
choose the main-dimensions to give a cheap design.
Assume:
Winding factor = 0.955, stacking factor = 0.9
Example 10.1 cont’d

•   Main dimensions
(i)

For a cheap design ratio, L/τ = 1.5 to 2 taking L/τ = 1.5

or
Example 10.1 cont’d

•  

The length of core is 0.13 m; therefore, one radial duct 10 mm wide is provided
Example 10.1 cont’d

•   Turns per phase


(ii)

(iii) Number of stator slots


“Slot pitch should not be
below 10 mm”
Example 10.1 cont’d

•   Winding details
(iv)

• 3 slots per pole phase


• 9 slots per pole
• Coil span is 9 slots

https://en.wikipedia.org/wiki/Three-
Example: The coil span should be odd
Example 6.24

•   a winding diagram for a 4 pole, 24 slots, 3 phase mush connected armature.


Draw

Solution:
(Even number)
Consider, coil span = 5 slots

3 phase, 24 slots, 4 pole single layer mush


winding (Phase R)

“Coil span should be odd


number in mush winding”
Name plate
Discussion

Thanks
?

You might also like