LTE Product-SDR BBU&RRU Hardware
ZTE University
LTE Targets
Better Latency
coverage CP: 100ms
UP: 5ms
Flexible Bandwidth
1.4M
Unpaired-pectrum
3M
5M
Paired-Spectrum
10M
15M
20M
LTE Structure
MME / S-GW MME / S-GW
Mobility Management
EPC Serving Gateway
S1 Interface between
EPS MME/SGW & eNodeB
eNodeB
RNC
E- Node B eNodeB
X2 X2
UTRAN
eNodeB
X2
eNodeB
+ =
Interface between
eNodeBs
Only one Node in E-UTRAN – eNodeB Flexible band width
Evolved Packet Core – EPC Higher spectrum efficiency
Evolved Packet System – EPS High peak rate, Lower latency
Flat and IP-based Network Architecture for LTE
WCDMA/HSPA LTE Flat Structure
Without RNC
MSCS GGSN
MME x-GW •Less investment
HLR HSS PCRF
•Easy maintenance
EPC
MGW SGSN
•Reduce transmission
RNC RNC
delay
IP Backbone IP Backbone
•Better reliability
Node B Node B eNode B eNode B
MME/x-GW
Integrates CN & partial
RNC functions
Flat network structure and IP-based network can reduce the eNode B
TCO of LTE network. Full function of Node B
and major function of
RNC
Contents
Mobile Network Evolution
LTE Architecture and Benefits
ZTE LTE Products
ZTE Unified Radio Sub-System Platform
SDR- Software Defined Radio
OneNetwork Target
GSM/EDGE UMTS/HSPA TD-SCDMA CDMA2000 WiMAX LTE
GSM/EDGE
ZTE Universal SDR Platform UMTS/HSPA
LTE
Distributed IntegratedUniversal
RRU
RRU
RSU Features
MicroTCA architecture
Multi-Standard support
Baseband sharing and
BBU
software configurable
RRU sharing and
BBU
software configurable
Future-Proof
Future-Proof Platform
Platform with
with Smooth
Smooth Evolution
Evolution Support
Support
LTE Product Portfolio
INTEGRATED
Soft Defined Radio
2xMCPA, MIMO
2x40Watts TOC power, 40%
Multi-mode eNB Multi-mode eNB Femto eNB BS8210
Outdoor BS8900 Indoor BS8800 power efficiency for LTE
BBU+RRU
All IP transmission, provides
IP over E1/STM-1 interface
Unified O&M for simultaneous
Multi-mode BBU Multi-mode BBU Multi-mode RRU running RATs
Outdoor B8201 Indoor B8200 R8880
ZTE SDR PRODUCTS ADAPT TO TECHNOLOGY
DIVERSITIES TCO reduction comparing with
traditional solution
HSPA HSPA+ LTE
Open Structure Standard B8200
FRONT SIDE TOP
Single RAN concept Standard CPRI V3 Multi-mode with diff. Micro-TCA structure,
multi-mode product interface to RRU baseband cards compact 19”
installation
Hot backup Different RATs
power supplier apply different BP
cards, but share all
CPRI to RRU other parts
IP over E1 Hot backup Control + Clock + GE/FE
90 x 485 x 200 mm 7.33 Kg @ full config. 141W typical power Multi-mode
ZTE Baseband Unit—B8200
Slot 4 & 5 &11 Slot 8 to 10
Slot 12
Slot 1 & 2
FS BPL/BPN/BPK FM
PM
SA
Slot 3 CC Slot 6 & 7
Slot Module Description
1 to 2 PM Power Module, dual backup, -48VDC
3 SA Site Alarm module, IP over 8 x E1 interfaces
4 & 5 & 11 FS 6 pairs of optical interfaces on the BPL board
6 to 7 CC Control & Clock module, O&M interface, 2 x GE/FE
1 x BPL/BPN/BPK with 20MHz bandwidth and
8 to10 BPL/BPN/BPK
3x3.072G CPRI
12 FM Fan Module
CC Board Front Panel
BPL Board Front Panel
There are 6 pairs of optical interfaces on the BPL board,
which are mainly used to connect to eRRU.
Advanced SDR R8880
90o 90o 90o
UP
FRONT LEFT REAR RIGHT DOWN
– DIMENSION: 470 x 340 x 130 mm
Single RAN concept
– VOLUME: 20 Liter multi-mode product
– WEIGHT: 18 Kg Standard CPRI V3
interface to BBU
– PA POWER: 2 x 53 Watts MCPA
All bands, full series
– TOC POWER: 2 x 40 Watts products
– MULTI-MODE: Same frequency GSM/UMTS/LTE
Natural cooling, no fans
– TYPICAL POWER CONSUMPTION: 200 Watts
ZTE SDR R8880
ZTE SDR R8880
Features
Bandwidth Up to 20 MHz
Transmission Power 2×40 W (GU), 2*35W(LTE)
Frequency Band 2600/AWS/700/DD/1800/2100/900
Bandwidth support 1.4MHz, 3MHz, 5MHz, 10MHz,
15MHz, 20MHz
Size 470mm×340mm×130mm
Weight 18Kg
Power mode -48V DC (-37~-60V DC)
Power Consumption 200w
R8880 supports triple mode RATs: GSM, UMTS &
Waterproof/Dustproof IP65 LTE.
The reasonable configuration are:
Temperture Long-term: -40 ~ +55 °C
Short-term: -45 ~ +65 °C 850MHz
GSM + LTE
900MHz
GSM + LTE, GSM + UMTS, UMTS + LTE
Receiver Sensitivity 1.4MHz: -108.8 dBm
3MHz: -105.0 dBm 1800MHz GSM + LTE, UMTS + LTE
5/10/15/20MHz: -103.5 dBm 1900MHz GSM + LTE
2100MHz
UMTS + LTE
Relative humidity 5% ～ 100%
RRU GLOBAL SYSTEM ARCHITECTURE
eRRU External Port
eRRU External Port on Top and Bottom ：
Top Bottom
eRRU Interface Descriptions
：
No Label Interface Descriptions No. Label Interface Discription
.
1 ANT1 TRX port connect to Antenna 5 CPI1 OPTICAL FIBER
CONNECTION EBBU
2 ANT2 TRX port connect to Antenna 6 CPI2 CASCADING OPTICAL
FIBER
3 AISG/MON Contact/RS485/AISG Interface 7 PWR Power Port ， DC-48V
4 LMT Local Maintenance Test Port /FE 8 GND Protection Ground
Port
GSM/LTE Dual-mode System to Co-existence with
UMTS
08’ Q4 launch GSM LTE
ZTE SDR
Platform
LTE hardware ready
Cost effective solution
GSM/LTE Dual-mode Platform
+10 years GSM system G/L dual-mode LTE system
1. Replace by GSM/LTE 2. Software upgrade
dual-mode system
GSM/UMTS operators can build a new GSM/LTE network to replace the old GSM system.
The existed UMTS network co-existence with GSM/LTE system.
By software upgrade, the GSM spectrum can refarm to future single LTE system.
UMTS/LTE Dual-mode System to Prove Future
Evolution
UMTS/LTE System UMTS/LTE System
Existed GSM system
GSM System
2. GSM replace by
U/L system
1. Build a new UMTS/LTE
dual-mode system
3. Software upgrade
LTE system
UMTS LTE
GSM operators can build a new U/L network to launch 3G first.
The existed GSM network co-existence with U/L system.
By software upgrade, the GSM spectrum can refarm to U/L system.
UMTS/LTE dual-mode Platform
Jinja GolfClub-3G&4G
Lira-2G&3G&4G
ZXSDR Network Combination Mode
StarMode: maximum 9 eRRUs Connected to eBBU
Chain Mode: : maximum 4 eRRUs Cascading
