Scribd
Upload
5 views13 pages

Additional Examples

The document is a worksheet focused on various problems related to communication systems, specifically addressing amplitude modulation (AM) and single sideband (SSB) systems. It includes calculations for power content, signal-to-noise ratio (SNR), modulation types, and noise figures in radio receivers. The problems require applying concepts of modulation, noise, and signal processing to derive solutions.

Uploaded by

Wami Mahammad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
5 views13 pages

Additional Examples

The document is a worksheet focused on various problems related to communication systems, specifically addressing amplitude modulation (AM) and single sideband (SSB) systems. It includes calculations for power content, signal-to-noise ratio (SNR), modulation types, and noise figures in radio receivers. The problems require applying concepts of modulation, noise, and signal processing to derive solutions.

Uploaded by

Wami Mahammad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 13

Introduction to communication system-

Worksheet
1. The total power content of an AM signal is 1000W. Determine
the power being transmitted at carrier frequency and at each side
bands when modulation percentage is 100%.
2.
4. In a SSB system, the message signal is a single tone, of frequency 3 𝑘𝐻𝑧,
and peak amplitude 14 volt, the receiver input impedance is 50 Ω, the
equivalent noise spectral density at the input is 10-14 watt/Hz (two sided) and
the path losses is 30 dB. If the input noise power is considered in the entire
signal bandwidth, find:
A. SNR at receiver input.
B. SNR at receiver output.
Solution:
5. A carrier signal given by 𝑐𝑜𝑠𝜔 𝑐 𝑡 is modulated by a single tone signal given
by 𝑓(𝑡) = 0.3𝑐𝑜𝑠𝜔 𝑚𝑡 (𝜔 𝑚 ≪ 𝜔 𝑐 ). Determine and plot the envelope of the
modulated signal in the following modulation types are used:
1- AM/DSB-LC (AM)
2- AM/SSB-LC (AM)
Solution:
6. A carrier signal given by cos( 2𝜋 × 105𝑡) 𝑣𝑜𝑙𝑡 is AM/SSB+SC modulated by
the message signal given by 4 cos(2𝜋 × 103𝑡) 𝑣𝑜𝑙𝑡:
1- Sketch the spectrum of modulated wave
2- Calculate the sideband power and transmission efficiency
3- Calculate the transmission bandwidth
Solution:
7.
Cont…
Cont…
Cont…
8. Radio receiver with equivalent bandwidth of 10 KHz has a noise
figure of 20 dB. If input SNR to receiver is 40 dB, determine the
output SNR . What is the equivalent Noise temperature, if
ambient temperature is 300k.
Solution
9. If each stage had a gain of 10 dB, and noise figure of 10 dB,
then what is the overall Noise figure of a two stage cascade
amplifier?
Solution

You might also like