Amesa mercury sorbent trap system datasheet

Amesa mercury sorbent trap system datasheet

• 1.
  AMESA-M Total Mercury Analyser Monitoringsystem for fully-automatic and continuous mercury analysis in smoke gas (without wet chemistry) Already MCERTS and TÜV accredited for continuous dioxin and furan KEYBENEFITS monitoring, the AMESA - M has been adapted for mercury monitoring. • Maintenance-free (6 months) dry AMESA - M extracts a sample from the flue gas stream under volume reactor proportional conditions. • • • • Consisting of a sample probe assembly and a control cabinet, the High operational safety Easy maintenance Internal Data Logging Functionality Low cross sensitivities The unit can store up to a four week period of sampling data which is Thermal mass flow meter to control then available to download via a USB flash drive. Analysis can be achieved mass flow independent of gas & with an onsite analyser or a certified laboratory. pressure Dry gas meter to determine sample Measuring Principle volume The sample gas is converted into mercury vapour by a combination of thermal and dry chemical treatment. This is then continuously measured in a photometer. Probe gas flow is measured after a gas cooler at 2°C. The concentration is calculated and displayed as dry flue gas. “ Providing continuous Mercury monitoring, The AMESA - M is suited for audit & control purposes “ •
• 2.
  TECHNICALSPECIFICATION APPLICATIONS • Waste incinerations •Sewage sludge incineration • Contaminated soil burning plants • Mercury mines and refineries • Fluorescent light bulb recycling plants MEASUREMENT PRINCIPLE • Measurements: total mercury • Measuring ranges 0–45 to 0–500 μg/Nm³ • Measuring principle: UV-absorption POWER • Measuring outputs: 2 x 0 / 4–20 mA/500 Ohm • Digital outputs: 4 relay outputs, permissible load 250 V, 100 VA • Digital inputs: 1 potential free outputs • Supply voltage: 230 VAC, 50 Hz, 1200 VA sample probe: 650 VA sample line: 100 VA/m SPAN & DRIFT • Accuracy: <1% of measuring range • Detection limit: <1 μg/Nm³ • Reference point drift: <2% of measuring range/month • Zero point drift: automatic zero correction TEMPERATURE & PRESSURE • Flue gas temperature: 0–250 °C • Flue gas pressure: -50 up to +50 hPa • Ambient temperature: +5 bis +30°C APPROVALS • MCERTS • TÜV Certified PHYSICAL • Dimensions: cabinet 1600 x 800 x 500 mm (H x W x D) • Weight: 220 kg • Duct diameter: >0.5 m Complete Project Solutions Our complete project solutions are developed to assist you in IED compliance. We achieve this through; • • • • • Expert consultancy Project management In-house project design & build Installation & commissioning After product service & support 11 Ark Royal Way, Lairdside Technology Park, Tranmere, Wirral, CH41 9HT T: +44(0)151 666 8300 F: +44(0)151 666 8329 E: [email protected] W: www.a1-cbiss.com Buy Online: shop.a1-cbiss.com Cert No. 996 ISO 9001