Downloaded 2,269 times
Uploaded byAngelica Nhoj Gemora
Blood collection
This document provides guidelines for routine venipuncture and specimen handling. It describes the venipuncture procedure, including patient preparation, vein selection, order of draw, labeling samples, and troubleshooting incomplete collections. It also lists the additive, function, and uses of various colored collection tube types, such as red top for chemistries, gold top for serum separation, and purple top for complete blood counts. Complications like hematomas are addressed.
More Related Content
Similar to Blood collection
Blood collection
- 1. BLOOD COLLECTION: ROUTINE VENIPUNCTURE AND SPECIMEN HANDLING
- 2. Objectives: Describe and perform the venipuncture process Identify the additive, additive function, volume, and specimen considerations to be followed for each of the various color coded tubes. List six areas to be avoided when performing venipuncture and the reasons for the restrictions.
- 3.
- 4. VENIPUNCTURE PROCEDURE Identify the patient. Assess the patient's physical disposition (i.e. diet, exercise, stress, basal state). Check the requisition form for requested tests, patient information, and any special requirements. Select a suitable site for venipuncture. Prepare the equipment, the patient and the puncture site.
- 5. 6. Performthe venipuncture. 7. Collect the sample in the appropriate container. 8. Recognize complications associated with the phlebotomy procedure. 9. Assess the need for sample recollection and/or rejection. 10. Label the collection tubes at the bedside or drawing area. 11. Promptly send the specimens with the requisition to the laboratory.
- 6. ORDER FORM /REQUISITION Patient's surname, first name, and middle initial. Patient's ID number. Patient's date of birth and sex. Requesting physician's complete name. Source of specimen. This information must be given when requesting microbiology, cytology, fluid analysis, or other testing where analysis and reporting is site specific.
- 7. Source of specimen.This information must be given when requesting microbiology, cytology, fluid analysis, or other testing where analysis and reporting is site specific. Date and time of collection. Initials of phlebotomist. Indicating the test(s) requested.
- 8. LABELING THE SAMPLE Patient's surname, first and middle. Patient's ID number. NOTE: Both of the above MUST match the same on the requisition form. Date, time and initials of the phlebotomist must be on the label of EACH tube.
- 9. Automated systems mayinclude labels with bar codes.
- 10. THE FOLLOWING ARENEEDED FOR ROUTINE VENIPUNCTURE: Evacuated Collection Tubes Needles Holder/Adapter Tourniquet Alcohol Wipes Povidone-iodine wipes/swabs Gauze sponges Adhesive bandages / tape Needle disposal unit Gloves Syringes
- 11. ORDER OF DRAW: 1. First - blood culture bottle or tube (yellow or yellow-black top) 2. Second - coagulation tube (light blue top). 3. Third - non-additive tube (red top) 4. Last draw - additive tubes in this order:
- 12. SST (red-gray orgold top). Sodium heparin (dark green top) PST (light green top). EDTA (lavender top) ACDA or ACDB (pale yellow top). Oxalate/fluoride (light gray top)
- 13. PROCEDURAL ISSUES PATIENT RELATIONS AND IDENTIFICATION The phlebotomist's role requires a professional, courteous, and understanding manner in all contacts with the patient. Proper patient identification MANDATORY . An outpatient must provide identification other than the verbal statement of a name.
- 14. PATIENT'S BILL OFRIGHTS: Impartial access to treatment or accommodations that are available or medically indicated, regardless of race, creed, sex, national origin, or sources of payment for care. Considerate, respectful care. Confidentiality of all communications and other records pertaining to the patient's care. Expect reasonable safety congruent with the hospital practices and environment.
- 15. o Know the identity and professional status of individuals providing service. Reasonable informed participation in decisions involving the patient's health care. Consult a specialist at the patient's own request and expense. Refuse treatment to the extent permitted by law. Regardless of the source of payment, request and receive an itemized and detailed explanation of the total bill for services rendered in the hospital. Be informed of the hospital rules and regulations regarding patient conduct.
- 16. VENIPUNCTURE SITE SELECTION: median cubital cephalic veins the basilic vein dorsal hand veins Foot veins
- 17. Certain areas areto be avoided when choosing a site: Extensive scars from burns and surgery The upper extremity on the side of a previous mastectomy Hematoma Intravenous therapy (IV) / blood transfusions Cannula/fistula/heparin lock Edematous extremities
- 18. PROCEDURE FOR VEINSELECTION: Palpate and trace the path of veins with the index finger. Arteries pulsate, are most elastic, and have a thick wall. Thrombosed veins lack resilience, feel cord-like, and roll easily. If superficial veins are not readily apparent, you can force blood into the vein by massaging the arm from wrist to elbow, tap the site with index and second finger, apply a warm, damp washcloth to the site for 5 minutes, or lower the extremity over the bedside to allow the veins to fill.
- 19. ADDITIONAL CONSIDERATIONS: To prevent a hematoma To prevent hemolysis (which can interfere with many tests) Indwelling Lines or Catheters Hemoconcentration Prolonged Tourniquet Application
- 20. Patient Preparation Factors Therapeutic Drug Monitoring Effects of Exercise Stress Diurnal Rhythms Posture Other Factors
- 21. SAFETY AND INFECTIONCONTROL PROTECT YOURSELF - Practice universal precautions: Dispose of needles immediately Clean up any blood spills with a disinfectant such as freshly made 10% bleach. If you stick yourself with a contaminated needle:
- 22. PROTECT THE PATIENTPlace blood collection equipment away from patients, especially children and psychiatric patients. Practice hygiene for the patient's protection.
- 23. TROUBLESHOOTING GUIDELINES: IF AN INCOMPLETE COLLECTION OR NO BLOOD IS OBTAINED: - Change the position of the needle. Move it forward (it may not be in the lumen)
- 24. - or move it backward (it may have penetrated too far).
- 25. Adjust the angle(the bevel may be against the vein wall).
- 26. Loosen the tourniquet. Try another tube. There may be no vacuum in the one being used. Re-anchor the vein. Veins sometimes roll away from the point of the needle and puncture site.
- 27. IF BLOOD STOPSFLOWING INTO THE TUBE: The vein may have collapsed; resecure the tourniquet to increase venous filling. If this is not successful, remove the needle, take care of the puncture site, and redraw. The needle may have pulled out of the vein when switching tubes. Hold equipment firmly and place fingers against patient's arm, using the flange for leverage when withdrawing and inserting tubes.
- 28. PROBLEMS OTHER THANAN INCOMPLETE COLLECTION: A hematoma forms under the skin adjacent to the puncture site - release the tourniquet immediately and withdraw the needle. Apply firm pressure.
- 29. The blood isbright red (arterial) rather than venous. Apply firm pressure for more than 5 minutes.
- 30. Red Top ADDITIVE None MODE OF ACTION Blood clots, and the serum is separated by centrifugation USES Chemistries, Immunology and Serology, Blood Bank (Crossmatch)
- 31. Gold Top ADDITIVE None MODE OF ACTION Serum separator tube (SST) contains a gel at the bottom to separate blood from serum on centrifugation USES Chemistries, Immunology and Serology
- 32. Gold Top ADDITIVE None MODE OF ACTION Serum separator tube (SST) contains a gel at the bottom to separate blood from serum on centrifugation USES Chemistries, Immunology and Serology
- 33. Light Green Top ADDITIVE Plasma Separating Tube (PST) with Lithium heparin MODE OF ACTION Anticoagulates with lithium heparin; Plasma is separated with PST gel at the bottom of the tube USES Chemistries
- 34. Purple Top ADDITIVE EDTA MODE OF ACTION Forms calcium salts to remove calcium USES Hematology (CBC) and Blood Bank (Crossmatch); requires full draw - invert 8 times to prevent clotting and platelet clumping
- 35. Light BlueTop ADDITIVE Sodium citrate MODE OF ACTION Forms calcium salts to remove calcium USES Coagulation tests (protime and prothrombin time), full draw required
- 36. Green Top ADDITIVE Sodium heparin or lithium heparin MODE OF ACTION Inactivates thrombin and thromboplastin USES For lithium level, use sodium heparin For ammonia level, use sodium or lithium heparin
- 37. Dark BlueTop ADDITIVE EDTA- MODE OF ACTION Tube is designed to contain no contaminating metals USES Trace element testing (zinc, copper, lead, mercury) and toxicology
- 38. Light Gray Top ADDITIVE Sodium fluoride and potassium oxalate MODE OF ACTION Antiglycolytic agent preserves glucose up to 5 days USES Glucoses, requires full draw (may cause hemolysis if short draw)
- 39. Yellow Top ADDITIVE ACD (acid-citrate-dextrose) MODE OF ACTION Complement inactivation USES HLA tissue typing, paternity testing, DNA studies
- 40. Yellow - BlackTop ADDITIVE Broth mixture MODE OF ACTION Preserves viability of microorganisms USES Microbiology - aerobes, anaerobes, fungi
- 41. Black Top ADDITIVE Sodium citrate (buffered) MODE OF ACTION Forms calcium salts to remove calcium USES Westergren Sedimentation Rate; requires full draw
- 42. Orange Top ADDITIVE Thrombin MODE OF ACTION Quickly clots blood USES STAT serum chemistries
- 43. Light Brown Top ADDITIVE Sodium heparin MODE OF ACTION Inactivates thrombin and thromboplastin; contains virtually no lead USES Serum lead determination
- 44. Pink Top ADDITIVE Potassium EDTA MODE OF ACTION Forms calcium salts USES Molecular/viral load testing
- 45. BLOOD COLLECTION ONBABIES: The recommended location for blood collection on a newborn baby or infant is the heel.
- 46. Prewarming the infant'sheel (42 C for 3 to 5 minutes) is important to obtain capillary blood gas samples and warming also greatly increases the flow of blood for collection of other specimens. However, do not use too high a temperature warmer, because baby's skin is thin and susceptible to thermal injury. Clean the site to be punctured with an alcohol sponge. Dry the cleaned area with a dry cotton sponge. Hold the baby's foot firmly to avoid sudden movement.
- 47. Using a sterileblood lancet, puncture the side of the heel in the appropriate regions shown above in green. Do not use the central portion of the heel because you might injure the underlying bone, which is close to the skin surface. Do not use a previous puncture site. Make the cut across the heelprint lines so that a drop of blood can well up and not run down along the lines.
- 48. Wipe away thefirst drop of blood with a piece of clean, dry cotton. Since newborns do not often bleed immediately, use gentle pressure to produce a rounded drop of blood. Do not use excessive pressure or heavy massaging because the blood may become diluted with tissue fluid.
- 49. Fill the capillarytube(s) or micro collection device(s) as needed. When finished, elevate the heel, place a piece of clean, dry cotton on the puncture site, and hold it in place until the bleeding has stopped. Be sure to dispose of the lancet in the appropriate sharps container. Dispose of contaminated materials in appropriate waste receptacles. Remove your gloves and wash your hands.