ⓒ
Virtual Network
Logical Network
VM
VM
VM
Logical L2 Switch Corpnet/
Internet
CloudPhysicalNetwork
Gen 2 or SP
Cloud
Cloud HV1
Cloud HV2
Cloud HV3
1. Automate Network Services
Provisioning
2. Micro segmentation to enhance
security (DMZ / PCI, etc.)
3. Augment Physical L4-7 Appliances
VM
VM
VM
L3Routing/NAT
Stateful FW
SLB
DHCP
DNS Redirect
IPsec
SSLVPN
Gateway
Services
Corpnet/
Internet
ⓒ
Compute Racks Infra Racks Edge Racks
WAN
Internet
L2
L3
Controller Node
• Virtual network hypervisor
• Massive scale
Hypervisor Service Modules
• Distributed network services
Gateway Software
• Integration with existing physical infra.
• V to V / V to P
ⓒ
ⓒ
ⓒ
ⓒ
ⓒ
ⓒ
ⓒ
• Simple
• Scalable
• High-bandwidth
• Fault-tolerant
• QoS-providing
One of the key goals of network virtualization is to provide virtual-to-physical network
abstraction.
ⓒ
Physical Network - Simple
• Teaming
• Load based
• LACP
• L3 ToR/leaf
• Default GW for VLANs
• Allows dynamic routing
ⓒ
• Different type of racks
• Compute: Hypervisors
• Infrastructure: management
• Edge: Connectivity
• Equal-Cost Multipathing
• Fixed number of hops
• Traffic is TCP/UDP
Physical Network - Scalable
ⓒ
• Calculate oversubscription
• 20x10Gbps servers – leaf
• 8x10Gbps leaf – spine
• = 2.5:1
• Add uplinks where necessary
(ECMP)
Physical Network - High-bandwidth
ⓒ
• Protection via routing protocol
• Link failures
• Switch downtime (upgrades)
Physical Network - Fault-tolerant
ⓒ
• Hypervisor trusted to set QoS
• L2: CoS
• L3: DSCP
• Values kept in VXLAN tunnel
Physical Network - QoS-Providing
ⓒ
ⓒ
ZERO TOUCH NETWORKING (ZTN)
The Big Cloud Fabric system provides Zero Touch Networking (ZTN) for switches.
ZTN uses the Open Network Install Environment (ONIE) boot loader to automate switch
installation and configuration.
Fabric switches in the Big Cloud Fabric run the Switch Light OS software, which is bundled with
the Big Cloud Fabric software.
ⓒ
• Configure two tenants: Green & Red
• Create logical segments for the tenants
• Assign workloads to respective logical
segments shown below:
ⓒ
• Create Layer 3 interface for tenant Green, segment QA
• Create System Tenant Router and add default routes
on Red and Green tenant routers to point to System
Tenant Router
• Add system interface to Green and Red tenant routers
• Add tenant interfaces to System Tenant Router
ⓒ
ⓒ
ⓒ
ⓒ

OVNC 2015-성공적인 Customer Optimized Datacenter 구축 방안

  • 2.
    ⓒ Virtual Network Logical Network VM VM VM LogicalL2 Switch Corpnet/ Internet CloudPhysicalNetwork Gen 2 or SP Cloud Cloud HV1 Cloud HV2 Cloud HV3 1. Automate Network Services Provisioning 2. Micro segmentation to enhance security (DMZ / PCI, etc.) 3. Augment Physical L4-7 Appliances VM VM VM L3Routing/NAT Stateful FW SLB DHCP DNS Redirect IPsec SSLVPN Gateway Services Corpnet/ Internet
  • 3.
    ⓒ Compute Racks InfraRacks Edge Racks WAN Internet L2 L3 Controller Node • Virtual network hypervisor • Massive scale Hypervisor Service Modules • Distributed network services Gateway Software • Integration with existing physical infra. • V to V / V to P
  • 4.
  • 5.
  • 6.
  • 7.
  • 8.
  • 9.
  • 10.
    ⓒ • Simple • Scalable •High-bandwidth • Fault-tolerant • QoS-providing One of the key goals of network virtualization is to provide virtual-to-physical network abstraction.
  • 11.
    ⓒ Physical Network -Simple • Teaming • Load based • LACP • L3 ToR/leaf • Default GW for VLANs • Allows dynamic routing
  • 12.
    ⓒ • Different typeof racks • Compute: Hypervisors • Infrastructure: management • Edge: Connectivity • Equal-Cost Multipathing • Fixed number of hops • Traffic is TCP/UDP Physical Network - Scalable
  • 13.
    ⓒ • Calculate oversubscription •20x10Gbps servers – leaf • 8x10Gbps leaf – spine • = 2.5:1 • Add uplinks where necessary (ECMP) Physical Network - High-bandwidth
  • 14.
    ⓒ • Protection viarouting protocol • Link failures • Switch downtime (upgrades) Physical Network - Fault-tolerant
  • 15.
    ⓒ • Hypervisor trustedto set QoS • L2: CoS • L3: DSCP • Values kept in VXLAN tunnel Physical Network - QoS-Providing
  • 16.
  • 17.
    ⓒ ZERO TOUCH NETWORKING(ZTN) The Big Cloud Fabric system provides Zero Touch Networking (ZTN) for switches. ZTN uses the Open Network Install Environment (ONIE) boot loader to automate switch installation and configuration. Fabric switches in the Big Cloud Fabric run the Switch Light OS software, which is bundled with the Big Cloud Fabric software.
  • 18.
    ⓒ • Configure twotenants: Green & Red • Create logical segments for the tenants • Assign workloads to respective logical segments shown below:
  • 19.
    ⓒ • Create Layer3 interface for tenant Green, segment QA • Create System Tenant Router and add default routes on Red and Green tenant routers to point to System Tenant Router • Add system interface to Green and Red tenant routers • Add tenant interfaces to System Tenant Router
  • 20.
  • 21.
  • 22.
  • 23.