Downloaded 24 times
More Related Content
measurement of infiltration
- 3. This consistof metal cylinder of diameter 25 cm to 30 cm and length of 50 cm to 60 cm, with both ends open. length of cylinder= ( 2 x diameter ) It is driven into a level ground such that about 10 cm of cylinder is above the ground. Water is poured into the top part to a depth of 5 cm & pointer is set inside the ring to indicate the water level to be maintained.
- 4. The singlering involves driving a ring into the soil and supplying water in the ring either at constant head or falling head condition. Constant head refers to condition where the amount of water in the ring is always held constant means the rate of water supplied corresponds to the infiltration capacity. Falling head refers to condition where water is supplied in the ring, and the water is allowed to drop with time. The operator records how much water goes into the soil for a given time period.
- 5. The majordrawback of the single ring infiltrometer or tube infiltrometer is that the infiltrated water percolates laterally at the bottom of the ring. Thus the tube is not truly representing the area through which infiltration is taking place.
- 7. This ismost commonly used flooding type infiltrometer. it consists of two concentric rings driven into soil uniformly without disturbing the soil to the least to a depth of 15 cm. The diameter of rings may vary between 25 cm to 60 cm. An inner ring is driven into the ground, and a second bigger ring around that to help control the flow of water through the first ring. Water is supplied either with a constant or falling head condition, and the operator records how much water infiltrates from the inner ring into the soil over a given time period.
- 10. plot ofland (2m X 4m) The specially designed nozzles produce raindrops falling from height of 2m under controlled conditions with various combinations of intensities & durations and the surface runoff rates and volumes are measured in each case. P – R – G – E - T = ∆S