This information is from:
[Link] which was
originally written in the german language. This has been translated by Dion Stevenson
of [Link].
I acknowledge the work carried out by the german writers and thank them for their
service to Marklin followers world wide.
Measurement Parameters:
• Analogue Motor :: 16Vac at 50Hz
• Analogue with Electronic Control :: 16V * crest factor of 0.9 = 14.4V, 14.4V-3.5V (voltage drop caused by
transistors) = 10.9V at 100Hz
• Digital :: Motor voltages calculate to be:
:: Transformer voltage = 16V * crest factor of 1.4.
:: Central Controller (6021) = 22.4V - 4.2V voltage drop caused by the transistors in the central
processing unit provides 18.2V to the track
:: Track voltage is affected by the decoder used:
:: ::Delta Decoder :: 18.2V * crest factor or 1 (square-wave impulses) – 3.5V voltage drop caused
by transistors decoder =14.7V, 75Hz with no regulation
:: :: 6090(x) Decoders ::18.2V*Form factor of 1 – 4.2V voltage drop caused by transistors on
decoder = 14V, 250Hz with regulation (approximate value for 60901-decoder)
• P1 represents the maximum current draw of the motor (important for the output stages of controlling
electronics)
• P2 represents the maximum usable current draw of the motor with field coils???
Note: the following table is based on own measurements and computations!
Engine-specific losses remain unconsidered.
All information is provided without any guarantee!
What is form factor? :: It is the ratio of RMS (Root Mean Square) of an AC signal to a DC voltage. This ultimately
provides a method of calculating an AC voltage to provide same effective power across a known resistive load if
DC was used.
MotorType Number Analog Electronics Digital Picture Remarks and
examples (NO
GUARANTEE!)
P1(P2) P1(P2) P1(P2)
Series Motors (Field Coil), Digital with Regulation
SFCM 200680 22.3W 9.0W 14.5W* 8 Teeth on the axis
(5.6W) (2.3W) (3.6W#) 3000 (till 1995),
3001, 3003, 3005,
3031, 3034 (till
1975), 3064, 3074,
3095 ...
Field Magent Type
200620, 214010,
214070, 214860,
215330, 401300,
405490
Page 1 of 6
LSFCM (RE800-11U2) ? ? ? ? Only in RE 800
LFCM1 202930 29.4W 11.4W 23.1W* 7 Teeth on the axis
(7.6W) (2.8W) (5.8W#) 3004, 3007, 3008,
3009, 3011, 3012,
3013, 3014, 3021, ...
Field Magent Type
202870, 211440,
217100, 222180,
222200, 250120
LFCM2 205800 26.6W 9.9W 20.4W* 7 Teeth on the axis
(6.7W) (2.5W) (5.1W#) G800, GN800, 3009,
3027, 3045, 3046,
3047, 3108
Field Magent Type
202870, 211440,
217100, 222180,
222200, 250120
LFCM3 217450 31.7W 12.0W 25.0W* 8 Teeth on the axis
(7.9W) (3.0W) (6.3W#) 3022, 3041, 3043,
3050, 3051, 3052,
3053, 3089, 3094, ...
Field Magent Type
202870, 211440,
217100, 222180,
222200, 250120
LFCM4 (TT800-11U3) 29.4W 11.4W 23.1W* 7 Teeth on the axis
(7.6W) (2.8W) (5.8W#) only in 3006/TT800
Feldmagnet Type
202870
SLFCM 207070 61.0W 26.5W* 50.1W* 10 Teeth on the axis
(15.2W) (6.4W#) (12.5W#) DL800, DT800,
ST800, 3010, 3015,
3017, 3025, 30159,
36159
Field Magent Type
207010, 208810
Page 2 of 6
DCM1 231440 13.6W 5.4W 10.8W 7 Teeth on the axis
(3.4W) (1.4W) (2.7W) 3000 (since 1996),
3033, 3034 (since
1976), 3084, 3085,
3102, 3489, ...
Field Magent Type
231390, 237550,
237560
DCM2 245480 20.6W 8.2W 16.3W* 7 Teeth on the axis
(5.2W) (2.1W) (4.1W#) 34155, 34156,
34157, 34158,
34159, 34611,
34612, ...
Field Magent Type
231390, 237550,
237560
FDCM 610030 27.9W 11.9W 22.7W* 7 Teeth on the axis
(7.0W) (3.0W) (5.7W#) 3502, 3504, 3553,
3557, ...
Feldmagnet Type
231390
Rotors used with Permanent Magnets, Digital with regulation
SFCM 200680 § 18.6W* 14.8W* 8 Teeth on the axis
(4.6W#) (3.7W#) 8303, 8398, ...
Permanentmagnet
220450
LFCM1 202930 § 19.2W* 17.2W* 7 Teeth on the axis
(4.8W#) (4.3W#) 8373, ...
Permanentmagnet
220560
Page 3 of 6
LFCM2 205800 § 16.7W* 11.5W* 7 Teeth on the axis
(4.2W#) (2.9W#) 8345, 8346, 8347
Permanentmagnet
220560
LFCM3 217450 § 25.0W* 24.2W* 8 Teeth on the axis
(6.3W#) (6.1W#) 3722, 8322, 8389,
8394, ...
Permanentmagnet
220560
DCM1 231440 § 7.7W 6.9W 7 Teeth on the axis
(1.9W) (1.7W) 8342, 8317, 8313,
8306, ...
Permanentmagnet
235690
DCM2 245480 § 15.7W* 13.8W* 7 Teeth on the axis
(3.9W#) (3.5W#) 8360, ...
Permanentmagnet
235690
FDCM 610030 § 34.7W* 38.2W* 7 Teeth on the axis
(8.7W#) (9.6W#)
Permanent magnet
235690
Page 4 of 6
DDCM1 386820 § 0.8W& 6.9W 7 Teeth on the axis
(0.2W&) (1.7W) 3701, 3702, 3704,
3710, ...
Permanent magnet
389000, 449390
DDCM2 210888 § 0.8W& 6.9W 8 Teeth on the axis
(0.2W&) (1.7W) fünfpoliger DC-
Motor,
60903/4-Ersatz für
SFCM/LFCM3
Permanent magnet
210882
DDCM3 214118 § 0.8W& 6.9W 8 Teeth on the axis
(0.2W&) (1.7W) Five Pole DC-Motor,
60904 replacement
for LFCM1,2,4
Permanentmagnet
210882
DDCM4 306602 § 0.8W&? 6.9W? 8 Teeth on the axis
(0.2W&?) (1.7W?) Five Pole DC-Motor,
DDCM with ball
bearing for VT11.5
Permanent magnet
306605
FH1319-12S 602620 § 6.5W 6.1W@ Bell Motor
(1.6W) (1.5W@) 3311, 3411, 3511,
3513, 3514, 3611,
3613, 3614, 3711,
34112, 37112, ...
Page 5 of 6
Brushless Synchronus Motor (Permanent Magnet)
Sinus-Motor § 5W 8W? brushless
synchronous motor
(?????) (3W?) (5W?) 39103, 39370, ...
§ Engine without electronics in the adaptive command system not operable
&
Engine is operated also in the analog enterprise with regulation, data for 6090 electronic
*
Use with standard Decoder not possible
#
Use with standard Decoder not possible
@
Electronics without regulation in the digital environment
Page 6 of 6
