Scribd
Upload
2K views3 pages

Bighorn Fault Codes

The document lists diagnostic fault codes for a Bighorn vehicle. It provides a code number and description for various vehicle systems that could cause issues like the oxygen sensor, coolant sensor, starter, fuel injection, and more. It also provides instructions for accessing the codes with different connector types and clearing them by removing a fuse.

Uploaded by

jairaeder
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
2K views3 pages

Bighorn Fault Codes

The document lists diagnostic fault codes for a Bighorn vehicle. It provides a code number and description for various vehicle systems that could cause issues like the oxygen sensor, coolant sensor, starter, fuel injection, and more. It also provides instructions for accessing the codes with different connector types and clearing them by removing a fuse.

Uploaded by

jairaeder
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
  • Bighorn Fault Codes
  • Auto Diagnostic Navigation & Instructions
  • Example Model Code Use

BIGHORN FAULT CODES

If you have a 3 pin diag connecter above the pedals bridge terminals 1&3, switch ign on
don't start engine. Codes are ; 12 no fault, 13 oxygen sensor circuit, 14 coolant sensor, 15
coolant sensor, 21 throttle switch, 22 starter signal, 23 power transistor, vac switch valve, 26
carbon filtersolenoid high voltage, 27 carbon filter solenoid low voltage, 33 fuel inj circuit,
35 power transistor, 41 crank sensor, 43 throttle switch, 44 oxygen sensor, 45 oxygen
sensor, 51 ecu, 52 ecu, 53 vac switching valve for pressure regulator, 54 ign control, 61
airflow sensor, 62 airflow sensor, 63 vehicle speed sensor, 64 fuel inj system, 65 throttle
switch, 66 knock sensor, 72 egr system, 73 egr system. To clear codes, switch off ign,
remove fuse 13 from fuse box. If you have the later 16 pin try earthing pin 6 to get codes up.

Hope this helps....

BIGHORN FAULT CODES If you have a 3 pin diag connecter above the pedals bridge terminals 1&3, switch ign on don't start engi

You might also like