TC74HC155AP/AF/AFN
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC74HC155AP,TC74HC155AF,TC74HC155AFN
Dual 2-to-4 Line Decoder 3-to-8 Line Decoder
Note: xxxFN (JEDEC SOP) is not available in
Japan.
The TC74HC155A is a high speed CMOS DUAL 2-to-4 LINE
DECODER fabricated with silicon gate C2MOS technology. TC74HC155AP
It achieves the high speed operation similar to equivalent
LSTTL while maintaining the CMOS low power dissipation.
It features dual 1-to-4 line demultiplexers with individual
strobe input (1G and 2G), individual data inputs (1C and 2C) and
common binary address inputs (A and B).
When both decoders are enabled by the strobes, the inverted
output of 1C data and non-inverted output of 2C data will be
brought to the selected output pins of each section.
A 1-to-8 line demultiplexer can be easily built up by providing
TC74HC155AF
a data signal to both the 1C and 2C inputs; the output order will
be 1Y3 (MSB), 1Y2, 1Y1, 1Y0, 2Y3, 2Y2, 2Y1, 2Y0 (LSB).
This device can be used as a 2-to-4 line decoder or a 3-to-8 line
decoder when 1C is held high and 2C is held low.
All inputs are equipped with protection circuits against static
discharge or transient excess voltage.
Features
• High speed: tpd = 12 ns (typ.) at VCC = 5 V TC74HC155AFN
• Low power dissipation: ICC = 4 μA (max) at Ta = 25°C
• High noise immunity: VNIH = VNIL = 28% VCC (min)
• Output drive capability: 10 LSTTL loads
• Symmetrical output impedance: |IOH| = IOL = 4 mA (min)
• ∼ tpHL
Balanced propagation delays: tpLH −
• Wide operating voltage range: VCC (opr) = 2 to 6 V
• Pin and function compatible with 74LS155
Weight
Pin Assignment DIP16-P-300-2.54A : 1.00 g (typ.)
SOP16-P-300-1.27A : 0.18 g (typ.)
SOL16-P-150-1.27 : 0.13 g (typ.)
1 2007-10-01
TC74HC155AP/AF/AFN
IEC Logic Symbol
Truth Table
Inputs Outputs Inputs Outputs
B A 1G 1C 1Y 0 1Y1 1Y 2 1Y3 B A 2G 2C 2Y0 2Y1 2Y 2 2Y3
X X H X H H H H X X H X H H H H
L L L H L H H H L L L L L H H H
L H L H H L H H L H L L H L H H
H L L H H H L H H L L L H H L H
H H L H H H H L H H L L H H H L
X X X L H H H H X X X H H H H H
X: Don’t care X: Don’t care
2 2007-10-01
TC74HC155AP/AF/AFN
System Diagram
Absolute Maximum Ratings (Note 1)
Characteristics Symbol Rating Unit
Supply voltage range VCC −0.5 to 7 V
DC input voltage VIN −0.5 to VCC + 0.5 V
DC output voltage VOUT −0.5 to VCC + 0.5 V
Input diode current IIK ±20 mA
Output diode current IOK ±20 mA
DC output current IOUT ±25 mA
DC VCC/ground current ICC ±50 mA
Power dissipation PD 500 (DIP) (Note 2)/180 (SOP) mW
Storage temperature Tstg −65 to 150 °C
Note 1: Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or
even destruction.
Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly
even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute
maximum ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 2: 500 mW in the range of Ta = −40 to 65°C. From Ta = 65 to 85°C a derating factor of −10 mW/°C shall be
applied until 300 mW.
3 2007-10-01
TC74HC155AP/AF/AFN
Operating Ranges (Note)
Characteristics Symbol Rating Unit
Supply voltage VCC 2 to 6 V
Input voltage VIN 0 to VCC V
Output voltage VOUT 0 to VCC V
Operating temperature Topr −40 to 85 °C
0 to 1000 (VCC = 2.0 V)
Input rise and fall time tr, tf 0 to 500 (VCC = 4.5 V) ns
0 to 400 (VCC = 6.0 V)
Note: The operating ranges must be maintained to ensure the normal operation of the device.
Unused inputs must be tied to either VCC or GND.
Electrical Characteristics
DC Characteristics
Ta =
Test Condition Ta = 25°C
Characteristics Symbol −40 to 85°C Unit
VCC (V) Min Typ. Max Min Max
2.0 1.50 ⎯ ⎯ 1.50 ⎯
High-level input
VIH ⎯ 4.5 3.15 ⎯ ⎯ 3.15 ⎯ V
voltage
6.0 4.20 ⎯ ⎯ 4.20 ⎯
2.0 ⎯ ⎯ 0.50 ⎯ 0.50
Low-level input
VIL ⎯ 4.5 ⎯ ⎯ 1.35 ⎯ 1.35 V
voltage
6.0 ⎯ ⎯ 1.80 ⎯ 1.80
2.0 1.9 2.0 ⎯ 1.9 ⎯
IOH = −20 μA 4.5 4.4 4.5 ⎯ 4.4 ⎯
High-level output VIN
VOH 6.0 5.9 6.0 ⎯ 5.9 ⎯ V
voltage = VIH or VIL
IOH = −4 mA 4.5 4.18 4.31 ⎯ 4.13 ⎯
IOH = −5.2 mA 6.0 5.68 5.80 ⎯ 5.63 ⎯
2.0 ⎯ 0.0 0.1 ⎯ 0.1
IOL = 20 μA 4.5 ⎯ 0.0 0.1 ⎯ 0.1
Low-level output VIN
VOL 6.0 ⎯ 0.0 0.1 ⎯ 0.1 V
voltage = VIH or VIL
IOL = 4 mA 4.5 ⎯ 0.17 0.26 ⎯ 0.33
IOL = 5.2 mA 6.0 ⎯ 0.18 0.26 ⎯ 0.33
Input leakage
IIN VIN = VCC or GND 6.0 ⎯ ⎯ ±0.1 ⎯ ±1.0 μA
current
Quiescent supply
ICC VIN = VCC or GND 6.0 ⎯ ⎯ 4.0 ⎯ 40.0 μA
current
AC Characteristics (CL = 15 pF, VCC = 5 V, Ta = 25°C, input: tr = tf = 6 ns)
Characteristics Symbol Test Condition Min Typ. Max Unit
tTLH
Output transition time ⎯ ⎯ 4 8 ns
tTHL
tpLH
Propagation delay time ⎯ ⎯ 12 22 ns
tpHL
4 2007-10-01
TC74HC155AP/AF/AFN
AC Characteristics (CL = 50 pF, input: tr = tf = 6 ns)
Ta =
Test Condition Ta = 25°C
Characteristics Symbol −40 to 85°C Unit
VCC (V) Min Typ. Max Min Max
2.0 ⎯ 30 75 ⎯ 95
tTLH
Output transition time ⎯ 4.5 ⎯ 8 15 ⎯ 19 ns
tTHL
6.0 ⎯ 7 13 ⎯ 16
2.0 ⎯ 45 130 ⎯ 165
Propagation delay tpLH
⎯ 4.5 ⎯ 15 26 ⎯ 33 ns
time tpHL
6.0 ⎯ 13 22 ⎯ 28
Input capacitance CIN ⎯ ⎯ 5 10 ⎯ 10 pF
Power dissipation CPD
⎯ ⎯ 53 ⎯ ⎯ ⎯ pF
capacitance (Note)
Note: CPD is defined as the value of the internal equivalent capacitance which is calculated from the operating
current consumption without load.
Average operating current can be obtained by the equation:
ICC (opr) = CPD･VCC･fIN + ICC
5 2007-10-01
TC74HC155AP/AF/AFN
Package Dimensions
Weight: 1.00 g (typ.)
6 2007-10-01
TC74HC155AP/AF/AFN
Package Dimensions
Weight: 0.18 g (typ.)
7 2007-10-01
TC74HC155AP/AF/AFN
Package Dimensions (Note)
Note: This package is not available in Japan.
Weight: 0.13 g (typ.)
8 2007-10-01
TC74HC155AP/AF/AFN
RESTRICTIONS ON PRODUCT USE 20070701-EN GENERAL
• The information contained herein is subject to change without notice.
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc.
• The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his
document shall be made at the customer’s own risk.
• The products described in this document shall not be used or embedded to any downstream products of which
manufacture, use and/or sale are prohibited under any applicable laws and regulations.
• The information contained herein is presented only as a guide for the applications of our products. No
responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which
may result from its use. No license is granted by implication or otherwise under any patents or other rights of
TOSHIBA or the third parties.
• Please contact your sales representative for product-by-product details in this document regarding RoHS
compatibility. Please use these products in this document in compliance with all applicable laws and regulations
that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses
occurring as a result of noncompliance with applicable laws and regulations.
9 2007-10-01
