Test No : 03
Trade : Machinist (1st Year)
Faculty : Mrs. Savita Mutal
Q 01) What is the cut of file?
A. Rasp cut
B. Curved cut
C. Double cut
D. Single cut
Q 02) What is the name of the part of the file marked ‘x’?
A. Tip
B. Heel
C. Tang
D. Shoulder
Q 03) Which is the most suitable pitch for hack saw blade for cutting high carbon steel?
A. 0.8 mm
B. 1.0 mm
C. 1.4 mm
D. 1.8 mm
Q 04) What is the other name of cross cut chisel?
A. Web chisel
B. Cape chisel
C. Diamond point chisel
D. Half round nose chisel
Q 05) What is the maximum carbon percentage of forgeable steel?
A. Up to 1%
B. Up to 1.2%
C. Up to 1.7%
D. Up to 3%
Q 06) What is the point angle of chisel to cut mild steel?
A. 45°
B. 50°
C. 55°
D. 60
1 of 4
Q 07) What is the angle of center punch?
A. 30°
B. 60°
C. 75°
D. 90°
Q 08) Which part of the hammer the handle is fixed?
A. Pein
B. Face
C. Check
D. Eye Hole
Q 09) What is the name of the part marked ‘X’?
A. Face
B. Pein
C. Cheek
D. Eye hole
Q 10) What is the grade of file used for rapid and larger quantity of metal removal?
A. Rough file
B. Bastard file
C. Smooth file
D. Second cut file
Q 11) Which grade of file is used to bring the material to accurate size with a high degree of finish?
A. Rough file
B. Bastard file
C. Second cut file
D. Dead smooth file
Q 12) Which grade of files remove small quantities of material and to give good finish?
A. Rough file
B. Smooth file
C. Bastard file
D. Second cut file
Q 13) Which file is used for filing narrow grooves and angle more than 10 degree ?
A. Round file
B. Triangular file
C. Half round file
D. Knife - edge file
2 of 4
Q 14) What is the purpose of ‘V’ groove provided on the base of universal surface gauge?
A. Used on irregular surface
B. Used on flat datum surface
C. Used on angular datum surface
D. Used on cylindrical datum surface
Q 15) What is the name of the instrument used for marking lines parallel to inside and outside edges?
A. Divider
B. Jenny caliper
C. Inside caliper
D. Outside caliper
Q 16) What is the use of a Half round nose chisel?
A. For cutting key - ways
B. For cutting curved grooves
C. For squaring material at the corners
D. For removing metal from flat surfaces
Q 17) What is the name of the chisel used to chip - off excess metal of welded joints and castings?
A. Flat chisel
B. Cross cut chisel
C. Diamond point chisel
D. Half round nose chisel
Q 18) Which caliper is used for marking parallel lines to the edge of the job?
A. Divider
B. Jenny caliper
C. Inside caliper
D. Outside caliper
Q 19) What material is used for making scriber?
A. Mild steel
B. High speed steel
C. High carbon steel
D. Medium carbon steel
Q 20) Which type of vice is used for gripping screws, rivets, keys and other similar objects?
A. Pin vice
B. Hand vice
C. Pipe vice
D. Quick release vice
====== X X ======
3 of 4
