Scribd
Upload
407 views2 pages

ATV320U15M2C Crane Settings

The document outlines parameter settings for the Schneider Electric ATV320U15M2C used in overhead cranes, including motor parameters, ramp settings, brake control, torque control, and safety protections. Key settings include a rated motor voltage of 400V, acceleration and deceleration times of 3 seconds, and an overload timeout of 60 seconds. It also specifies advanced application settings such as enabling anti-rollback and optional multi-speed operation.

Uploaded by

myeasyway102
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
407 views2 pages

ATV320U15M2C Crane Settings

The document outlines parameter settings for the Schneider Electric ATV320U15M2C used in overhead cranes, including motor parameters, ramp settings, brake control, torque control, and safety protections. Key settings include a rated motor voltage of 400V, acceleration and deceleration times of 3 seconds, and an overload timeout of 60 seconds. It also specifies advanced application settings such as enabling anti-rollback and optional multi-speed operation.

Uploaded by

myeasyway102
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Schneider Electric ATV320U15M2C - Overhead Crane Parameter Settings

1. Motor Parameters (Motor Nameplate Settings)

UnS - Rated Motor Voltage: 400V (check motor plate)

nCr - Rated Motor Current: e.g., 4.5A

FrS - Rated Motor Frequency: 50Hz

nSP - Rated Motor Speed (RPM): e.g., 1440 RPM

tFr - Motor Thermal Protection: Enabled

2. Ramp Settings (Smooth Acceleration/Deceleration)

ACC - Acceleration Time: 2-5 sec

DEC - Deceleration Time: 2-5 sec

dEC2 - Second Deceleration Time: Optional (Emergency stop)

3. Brake Control Settings

bLF - Brake Control Function: Enabled

tbr - Brake Release Delay: 200-300 ms

tbd - Brake Application Delay: 200 ms

brS - Brake Sequence Management: Enabled if needed

4. Torque Control / Load Handling Settings

LAC - Auto-tuning: Run Auto-Tune

ttr - Torque Limit: 120-150%

nOL - Current Limit: Set as needed

5. Protections Settings (Safety Related)

OLT - Overload Timeout: 60 sec

tHt - Motor Overheat Alarm: Active

SCS - Safe Torque Off (STO): Connect to E-Stop


Schneider Electric ATV320U15M2C - Overhead Crane Parameter Settings

6. Application Specific (Advanced Settings)

APF - Application Profile: Profile 2 (Hoisting)

Anti-rollback: Enable if needed

Preset Speeds: Optional Multi-speed operation

Summary of Example Values (1.5kW Motor)

UnS: 400V

FrS: 50Hz

nCr: 4.5A

ACC: 3 sec

DEC: 3 sec

tbr: 250 ms

tbd: 200 ms

OLT: 60 sec

ttr: 150%

You might also like