RVV-65M-R3VB
6-port sector antenna, 2x 698-960, 4x1710-2690 MHz, 65° HPBW, 3x
RET
3 Independent Arrays (1 Low band and 2 high bands) in a single radome housing with small
formfactor
Symmetrical high band arrays with consistent electrical performance
Excellent RF pattern control – over the full operating band and tilt range for desired coverage
and interference containment
Pluggable RET with retractable tilt scale
General Specifications
Antenna Type Sector
Band Multiband
Color Light Gray (RAL 7035)
Grounding Type RF connector inner conductor and body grounded to reflector and mounting
bracket
Performance Note Outdoor usage
Radome Material Fiberglass, UV resistant
Radiator Material Aluminum
Reflector Material Aluminum
RF Connector Interface 4.3-10 Female
RF Connector Location Bottom
RF Connector Quantity, high band 0
RF Connector Quantity, mid band 4
RF Connector Quantity, low band 2
RF Connector Quantity, total 6
Remote Electrical Tilt (RET) Information
RET Hardware CommRET v2
RET Interface 8-pin DIN Female | 8-pin DIN Male
RET Interface, quantity 1 female | 1 male
Input Voltage 10–30 Vdc
Internal RET Low band (1) | Mid band (2)
Power Consumption, active state, maximum 10 W
2W Page 1 of 4
©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025
RVV-65M-R3VB
Power Consumption, idle state, maximum 2W
Protocol 3GPP/AISG 2.0 (Single RET)
Dimensions
Width 397 mm | 15.63 in
Depth 157 mm | 6.181 in
Length 997 mm | 39.252 in
Array Layout
Port Configuration
Page 2 of 4
©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025
RVV-65M-R3VB
Electrical Specifications
Impedance 50 ohm
Operating Frequency Band 1710 – 2690 MHz | 698 – 960 MHz
Polarization ±45°
Total Input Power, maximum 800 W
Electrical Specifications
Frequency Band, MHz 698–787 783–806 806–960 1710–1880 1850–1920 1920–2180 2300–2500 2500–2690
Gain, dBi 12.8 13.2 14.1 14.8 14.8 15.5 16.2 16.5
Beamwidth, Horizontal, 67 64 62 70 70 67 62 61
degrees
Beamwidth, Vertical, degrees 23.4 21.7 19.5 12.7 12 11.4 10.3 9.6
Beam Tilt, degrees 3–16 3–16 3–16 2–12 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 18 18 19 17 18 18 20 19
Front-to-Back Ratio, 26 28 28 27 28 29 30 29
Copolarization 180° ± 30°, dB
Isolation, Cross Polarization, 25 25 25 25 25 25 25 25
dB
Isolation, Inter-band, dB 25 25 25 25 25 25 25 25
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
Page 3 of 4
©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025
RVV-65M-R3VB
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150 -150
Input Power per Port, 250 250 250 200 200 200 200 200
maximum, watts
Mechanical Specifications
Wind Loading @ Velocity, frontal 247.0 N @ 150 km/h (55.5 lbf @ 150 km/h)
Wind Loading @ Velocity, lateral 140.0 N @ 150 km/h (31.5 lbf @ 150 km/h)
Wind Loading @ Velocity, rear 398.0 N @ 150 km/h (89.5 lbf @ 150 km/h)
Wind Speed, maximum 241 km/h (150 mph)
Packaging and Weights
Width, packed 492 mm | 19.37 in
Depth, packed 277 mm | 10.906 in
Length, packed 1177 mm | 46.339 in
Weight, gross 20.4 kg | 44.974 lb
Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.andrew.com/ProductCompliance
ROHS Compliant
UK-ROHS Compliant
Included Products
BSAMNT-B95-01 – Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members.
Kit contains one scissor top bracket set and one bottom bracket set.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 4 of 4
©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025
