High Density Polyethylene Injection Molding
Product Description: Recommended Applications:
180M50 is a High Density Polyethylene manufactured HDPE 180M50 is designed to suite the following application
using Nova Chemical's Sclairtech Solution areas:
Polymerization Technology. 180M50 is a natural colored
• Injection molded housewares
polymer with excellent flow properties, very good
processability and excellent gloss. • Thin wall molded products.
Product Technical Datasheet
Typical Properties:
Tested Properties Test Method UOM Values*
Resin Properties
0
Melt Flow Index (190 C & 2.16 Kg) ASTM D 1238 gm/10 min 20
o 3
Density @ 23 C ASTM D 1505 gm/cm 0.950
Mechanical Properties
Tensile Yield Strength ASTM D 638 MPa 22
Elongation at Yield ASTM D 638 % 12
Flexural Modulus ASTM D 790 MPa 750
Hardness ASTM D 2240 Shore D 55
Thermal Properties
o
Vicat Softening Point (10 N) ASTM D 1525 C 124
* Typical values not to be construed as specification limits. Values may change without any prior notice.
* Mechanical properties tested on injection molded specimen.
o
Recommended Processing Temperature: 180 – 210 C
Packaging Information:
This material is packed and available in raffia bags with net content of 25.0 Kg only. The raffia bags used conforms to the minimum strength requirements of BIS,
however, customer shall take due care while handling the bag. Prolonged exposure of these bags to sunlight may deteriorate the bag’s performance and cause
spillage and wastage. IOCL does not warranty loss of material due to poor material handling practices.
Regulatory Information: Storage & Handling:
HDPE 180M50 shall meet “Specification for Polyethylene for safe Prevent HDPE Material from direct exposure to sunlight & heat to avoid quality
use in contact with Foodstuff, Pharmaceuticals and Drinking water” deterioration. The storage location should be dry, dust free and the Storage
as per IS: 10146-1982. It also confirms to the positive list of temperature should not exceed 50 oC. Non - compliance to these precautionary
constituents as per IS: 10141-1982. The grade and Additives measures can lead to degradation of the product causing Color changes, Odor &
incorporated shall meet with FDA: CFR Title 21, 177.1520, Olefin inadequate product performance. It is advised to process HDPE material within 06
Polymers. months after delivery.
Disclaimer: IOCL assumes no liability whatsoever in respect of application, processing or any use made of the aforementioned information or products, or any consequence thereof. No liability whatsoever shall attached to
any of the IOCL companies for any infringement of the rights owned or controlled by a third party in intellectual, industrial or other property by reason of application, processing or use of the afore-mentioned information or
products by the user.
Registered Office Address Contact Address Contact Details
G-9, Aliyavar Jung Marg, Product Application and Development Center (PADC), Tel : +91-180-2526702, 2526704
Bandra (East), Mumbai – 400051 Near Panipat Naphtha Cracker Complex, Fax : +91-180-2528689
Maharashtra, India. Village – Baljattan, Panipat – 132140, Haryana, India Web: https://propel.indianoil.in
00-12/13
